Lanaform Trimax Guide D'utilisation page 4

• Press "AUTO" to select the automatic mode. This unit has two programmes: circulation
EN
I and circulation II. Each time you press "AUTO", you can successively move through the
modes Manual – Circulation I – Circulation II – Manual.
1. Circulation I: Possibility of adjusting the vibration speed between 2 and 12.
2. Circulation II: Possibility of successively adjusting the vibration speed between 2-8-4-
• Select the appropriate time, temperature and speed depending on your state of health.
We recommend using the device between 1 and 3 minutes for every initial use in a
given place. Following this, change the time, temperature and speed according to your
wishes. It is vital that you select the functions beginning with a low level of intensity.
• Press "ON/OFF" to stop the power supply; then pull the plug out.
REMOTE CONTROL: TO BE USED IN MANUAL MODE
1) • POWER SUPPLY ON/OFF: to turn the device on or off .
2) • Infrared: to change the level of thermotherapy.
3) • Speed: to adjust the vibration speed.
4
Possibility of adjusting the infrared heat between 5 and 1. The time
between each change in mode is 8 seconds.
6-12-7-9-5. Possibility of adjusting the infrared heat: 5-5-4-4-1-1-3-3. The
time between each change in mode is 4 seconds.
[1]
[3]
[2]