Canon 35 Notice D'emploi page 8

Table i : With Macro attached
direetion to Auto Bellows (focusing ring at infinity)
Belleas Extension
39 50 60
Imml
2-3/4:
Shooting Imrnl 206 207
8.1/4 8.1/8 g.t/8 8-5/16
1.2
Field of View 32 x 2b 33 21
Table With FO 50mm 03.5 Macro tensattaehed in
1-15/16
Shooting 216 222
Distance 8-3/4
Magnification 1.5 1.7
Field of IGx23 12x 19
"voc
Tira'n• souffle'
30,5
1-9/16
v.]/te, 1-15/16
222
8-3/4
Grossissemont 1.4
Ch"mp 27
8
standard
du soufflet
70
Distance de (mm)
prise de Vue (in.)
Grossisgrnent
27
Champ
onto Auto Bellows Uoeusingring at infinity)
60 90
100
2-3/8 3-1/8 3-9,'16
4-5,'tG
229 236 244 253 261 270
9 9-5/16 96/8 9-15/16 10-5/8
1.9 2.3
2.9
10 x 16 14 13
au point
60 70 80 90 100
2-314 3.1/8 3-9/16 3-15/16 4-5/16
229 253 26 t 270
9 9-51B 9-15/16 10.1/4 10-5/8
2.3 2.5 2.7 29
9s 13
14
F 0 macro
coupleur au point infini)
39
70
1-1/2
1-15/16 24/8 2-314
210
8.1/4
8-1/8 8-1/8 8-5/16
1.2
32 48 25 x 37 21 xat 27
279
3.1
12 12
4.3/4
279
12 12
To avoid careless trimming, be sure to con-
firm the field of view in the viewfinder.
EXPOSURE
Even though the light reaching the film plane
is reduced due to accessories inserted between
the lens and the camera body, a camera with
a through-the-lens meter automatically takes
this into account and there
correct the exposure. No matter
lens is directly or reverse-mounted
bellows, take a stopped-down meter reading.
It is possible to do this two ways with the
Auto Bellows. You may use either the Canon
Double Cable Release, which is optionally
available for automatic diaphragm coupling,
or manual diaphragm control.
the latter. you must push the automatic ap-
erture lever at the rear of the lens to the right
where it locks before you mount the lens.
If you are using a separate exposure meter,
an incident light-reading meter
mended and it is necessary to correct
exposure reading using exposure
Please see the Auto Bellows instructions
information on how to use exposure factors.
SHOOTING PROCEDURE
Insert the slide into the slide insertion
so that the emulsion surface is facing out-
wards towards the light source and the
image is upright. Unfold
screen and check that the slide
all the way.
2. Check the color of the image through the
viewfinder. If it appears reddish, keep the
diffusion screen open while
Otherwise it should be closed while shoot-
ing.
is no need to
whether the
onto the
If you choose
is recom-
the
factors.
for
slot
the diffusion
is inserted
shooting.