Operation; Requirements At The Place Of Use; Adjusting The Clipping Pressure - Heiniger XPERIENCE Mode D'emploi

When not using the clipper, store it in the case making sure it is well
X X
cleaned, lubricated and that the clipping elements are not spring loaded
(risk of corrosion).
6

Operation

6.1

Requirements at the place of use

Observe the manual (see chapter 3 Technical data).
X X
Power outlets in the outer area must be equipped with a residual current
X X
circuit breaker (FI).
The work place must have adequate lighting.
X X
The electrical socket must be easily accessible so that the device can be
X X
quickly disconnected from the mains.
The charger power cord must not be taut or kinked.
X X
Make sure there is adequate ventilation.
X X
6.2

Adjusting the clipping pressure

Set the clipping pressure as follows before you start clipping:
Fig. 3
NOTE!
If the clipping pressure is too low, hair can gather between the
X X
clipping blades. This results in a poor clipping quality. In this
case, clean the clipping blades as described in chapter 6.7.
Instruction Manual / Xperience 2-Speed cattle clipper
Turn the adjusting knob in the direc-
X X
tion of the arrow until you feel resis-
tance.
Turn the knob another 1/4 turn in the
X X
direction of the arrow.
If the clipping quality deteriorates,
X X
increase the clipping pressure by
turning the adjusting knob another
1/4 turn in the direction of the arrow.
If this does not produce the desired
result, the blades must be replaced
or sharpened.
11