Noise Emission / Personal Protective Equipment; Other Dangers; Essential Operator Skills; Putting Into Operation - Heiniger 12V-S Mode D'emploi

BA Schaf S12 englisch:BA Schaf S12 englisch

2.4.3 Noise Emission / Personal Protective Equipment

Wear Ear Protectors!
Typical sound emissions when working are 84.3 dB(A). We recommend that ear protectors
should always be worn when working.
Wear Protective Goggles and Gloves!
For your personal protection we recommend that you wear protective goggles and gloves.
Personal protective equipment is to be provided by the operator.

2.4.4 Other Dangers

Should evidence of dangers or potential dangers, not directly related to the shearing of
animals, occur during operation, we would ask you to inform us. This also applies to
dangerous technical deficiencies.

2.5 Essential Operator Skills

Operating the machine safely makes only small demands of the operator. However, it is
essential that they are observed and carried out.
• The operator must be experienced in handling the animals to be shorn.
• The operator must have read and understood the instructions or have been instructed by
an expert in the machine's use and have had the potential dangers explained.
Children are not permitted to operate the equipment.

3 Putting into operation

3.1 Controls and Operating Notes

There are dangers inherent in the improper use of electrical equipment, especially stockbree-
ding equipment! Therefore, before using the machine, you should observe the following
accident-prevention measures:
• Observe the advisory notes listed at 2.4.1 (power connections)
• One or more lead storage batteries connected in parallel must be rated 12V. When
operating the machine from several storage batteries simultaneously, they must only be
parallel switched and never in series. In case of doubt contact a specialist.
• Avoid all contact with the moving shearing blades.
• Even when the machine is connected off, do not handle the area of the shearing blades
as long as the machine is connected to a power source. Always disconnect the power
supply first when working on the shearing blades/shearing head.
• Avoid touching any machine which is in contact with any liquids. Never shear wet
animals. Any liquid which has got into the machine will lower the electrical insulation.
There is then the danger of an electric shock or short circuit. Only clean the machine
when dry using a brush or the cleaning brush provided.
6
8.12.2009 8:51 Uhr Seite 6
Instruction manual S12