Heiniger XPERIENCE Mode D'emploi page 31

Fig. 7
NOTE!
Make sure the clipping blades are positioned correctly when
X X
installing the new or sharpened blades.
Fig. 8
1,5 – 2 mm
Fig. 9
Instruction Manual / Xperience 2-Speed cattle clipper
Place the new upper blade on the
X X
guiding tips of the pivot lever.
Apply a few drops of oil on the pol-
X X
ished surfaces of the upper blade.
Install the new lower blade. Align
X X
it so that the ground surface of the
lower blade protrudes approx. 1.5 -
2 mm above the point of the upper
blade.
Tighten the comb plate screws.
X X
13