To Stop The Product; Maintenance; Maintenance Schedule - Husqvarna 525P4S Manuel D'utilisation

CAUTION: Do not pull the starter rope all
the way out and do not let go off the
starter rope handle when the starter rope
is fully extended. This can cause
damage to the product.
6. Pull the starter rope again and again until the engine
starts.
7. Reset the choke when the engine fires.
8. Operate the throttle gradually when the engine
starts.
9. Make sure the engine runs smoothly.
About the surface
WARNING: Do not put parts of your body in
the grey marked area. If you touch the grey
marked area it can result in burns to the
skin. It can also cause electrical shock if the
spark plug cap has been damaged. Do not
use a product with a damaged spark plug
cap.
Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.

Maintenance schedule

The following is a list of the maintenance steps that must
be performed on the product. Most of the items are
described later in this chapter.

Maintenance

Clean the external surface.
Make sure that the throttle trigger lock and the throttle works correctly.
Do a check of the stop switch to make sure that it works correctly.
Make sure that the saw chain does not rotate at idle speed.
703 - 005 - 20.10.2020

To stop the product

1. Move the stop switch into the stop position to stop
the engine.
Maintenance
Note: The user must only carry out the maintenance and
service work described in this operator's manual. More
extensive work must be carried out by an authorized
service workshop.
CAUTION: The stop switch automatically
goes back to its initial position. In order
to prevent accidental starting, the spark
plug cap must be removed from the
spark plug when assembling, checking
and/or maintenance is done.
Daily Weekly
X
X
X
X
Monthly
15