Setting The Temperature; Additional Functions - Electrolux EK 226 RE WE Mode D'emploi

Switching the appliance on and off
You are recommended to clean the appliance before switching it
on for the first time (see „Cleaning").
Switching on: Press the On / Off button so that the
temperature display lights up/flashes.
Switching off: Press the On / Off button for approx. two
seconds so that the temperature display goes out.

Setting the temperature

To increase the temperature
Press the button.
To reduce the temperature
Press the button.
- When pressing one of the buttons for the first time, the display
will start to flash.
- Pressing this button again enables you to change the temperature
setting.
- The electronic controls will switch over automatically about
5 seconds after the last time you pressed the button, and the
actual temperature will be displayed.
- You can change the temperatures in the refrigerator between
9°C and 2°C.
If to appears in the display, the appliance has a fault.
F 0 F 5
Consult the customer service department.
Button
The button switches the refrigerator compartment to
maximum cooling. This is recommended particulary if
you wish to cool large quantities of fresh food as fast as
possible. The refrigeration temperature drops to the level
of the coldest temperature control setting.
Switching on: Press the

Additional functions

In set-up mode you can set the child-proof lock and adjust the
brightness of the display.
Activating set-up mode:
• Press the button
4
- The button flashes.
- The display shows c for child-proof lock.
Note: The value to be altered flashes.
• Select the required function by pressing the
c = child-proof lock,
h = display brightness
• Now select/acknowledge the function by pressing the
briefly:
> For c = child-proof lock,
press the / button to select
c1 = child-proof lock on or
c0 = child-proof lock off and acknowledge with the
button. When the symbol
lock is activated.
> For h = brightness,
press the / button to select
h1 = minimum to h5 = maximum brightness and
acknowledge with the
Exiting set-up mode:
• Exit the set-up mode by pressing the On/Off button
2 min. the electronic system switches over automatically. The
normal operating mode is activated again.
22
button briefly so that the LED comes on.
for approx. 5 seconds.
/ button:
is lit, the child-proof
button.
Equipment
You can re-arrange the storage
shelves as required.
Lift the glass shelf, align the recess
over the support and replace the shelf
in a higher or lower position.
Repositioning the door racks
- Lift door rack vertically, lift out to
the front and re-insert at a different
height, following these steps in the
reverse order.
The sectioned glass shelves
can be moved to make space for
tall containers. Place the shelf
rails provided, fig. 1, on the sup-
ports on the left and right at the
desired height.
fig. 1
Interior LED light
The interior light switches off auto-
matically after the door has been
opened for approx. 15 minutes.
If the interior light does not switch
on when the door is opened briefly,
but the temperature display is
working, the light may be defective.
button
The light intensity of the LED
light corresponds to laser
class 1/1M.
Important
The light cover may only be removed by customer service
staff. If the cover is removed, do not look directly at the
light through optical lenses from close distance. This can
damage your eyes.
; after
3
Insert the glass shelves and
1
as shown in fig. 2. The glass
2
shelf with the raised edge
2
must go at the back.
If you need to make space for
tall containers, simply slide
the front half of the sectioned
glass shelf carefully under-
neath the back half, fig. 2.
fig. 2