Climate Rating; Setting Up; Electrical Connection; Operating And Control Elements - Electrolux EK110SR Notice D'utilisation

Climate rating

The climate rating indicates the room
temperature at which the appliance may
be operated in order to achieve full refrig-
eration performance.
The climate rating is indicated on the
type plate.
The position of the type plate is shown in the section entitled
Description of the appliance.
Climate rating Room temperature
SN +10°C to +32°C
Do not operate the appliance outside the
specified room temperature range.

Setting up

• Standard EN 378 specifies that the room in which you install
your appliance must have a volume of 1 m
refrigerant used in the appliance, so as to avoid the formation of
inflammable gas/air mixtures in the room where the appliance
is located in the event of a leak in the refrigerant circuit. The
quantity of refrigerant used in your appliance is indicated on
the type plate on the inside of the appliance.
• Only use the appliance when it is installed.
Do not cover ventilation openings
•
or grille.

Electrical connection

Only operate the appliance with alternating current (AC).
The permissible voltage and frequency are indicated on the type
plate. The position of the type plate is shown in the section entitled
Description of the appliance.
The socket must be properly earthed and protected by a fuse.
The tripping current of the fuse must be between 10 A and 16 A.
The socket must not be situated behind the appli-
ance and must be easily accessible.
Do not connect the appliance using an exten-
sion cable or extension socket.
Do not use stand-alone inverters (conversion
of direct current to alternating current/three-
phase current) or energy-saving plugs. Risk
of damage to the electronic control system!
34

Operating and control elements

1
2
3
4
Symbols in the display
per 8 g of R 600a
3

Switching the appliance on and off

Switching the appliance on
Press the
up.
Switching the appliance off
Keep the
temperature display goes out.

Setting the temperature

Press the button, the next lower tem-
perature value in the temperature display
will light up.
Keep pressing the
sired value is displayed.
Recommended temperature setting: 5°C. An average temperature
of approx. -18 °C is then established in the freezer compartment.
After a certain period of operation, the interior temperature will
adjust to the value which has been set.
If F1 appears in the display, the appliance has suffered a fault. In
this case, contact the customer service department.
3 4
Temperature display (display)
Temperature setting button
On/Off button
ActionCool button (the ActionCool button switches the refrig-
erator compartment to maximum cooling)
Setup mode is activated (activating the child lock)
Child lock is activated
ActionCool ON symbol
button until the temperature display lights
button pressed for approx. 3 seconds so that the
button until the de-
1
2