Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating and control elements
Temperature display
1
Temperature buttons
2
On/Off button
3
button (The
button switches the refrigerator compartment
4
to maximum cooling)
Audible warning on/off button
5
Child lock
6
Switching the appliance on and off
You are recommended to clean the appliance before switching it
on for the first time (see „Cleaning").
Switching on: Press the On / Off button
display lights up/flashes.
Switching off: Press the On / Off button for approx. two seconds
so that the temperature display goes out.
Setting the temperature
To reduce the temperature
Press the
button.
To increase the temperature/warmer
Press the
button.
- While you are entering the temperature, the set temperature will
flash on the display.
- You can change the settings in increments of 1°C briefly pressing
the button again.
- The electronic controls will switch over automatically about
5 seconds after the last time you pressed the button, and the
actual temperature will be displayed.
- You can change the temperatures in the refrigerator between
9°C and 4°C.
• The temperature in the NaturaFresh compartment is controlled
automatically, between 0 and 3°C. If you want to increase or de-
crease the temperature, e.g. for storing fish, you can change the
NaturaFresh temperature yourself. See "Additional functions"
for more information.
If
to
appears in the display, the appliance has a fault.
F 0
F 5
Consult the customer service department.
Button
4
The
button switches the refrigerator compartment to maximum
cooling. This is recommended particulary if you wish to cool large
quantities of fresh food as fast as possible. The refrigeration tem-
perature drops to the level of the coldest temperature control setting.
Switching on: Press the
28
3
so that the temperature
3
2
button briefly so that the LED comes on.
Audible warning signal
The audible warning signal helps you to protect the food in your
refrigerator and save energy.
- It will sound when the door has been open for longer than about
1 minute.
• The signal will stop when you press the Alarm but-
ton
or automatically when you close the door.
5
Additional functions
In set-up mode you can set the child-proof lock, adjust the bright-
ness of the display and set the temperature in the NaturaFresh
compartment slightly lower or higher.
Activating set-up mode:
• Press the
button
for approx. 5 seconds.
4
- The
button flashes.
- The display shows c for child-proof lock.
Note: The value to be altered flashes.
• Select the required function by pressing the Up/Down button:
c = child-proof lock,
h = display brightness or
b = NaturaFresh temperature.
• Now select/acknowledge the function by pressing the
briefly:
> For c = child-proof lock,
press the Up/Down button to select
c1 = child-proof lock on or
c0 = child-proof lock off and acknowledge with the
button. When the symbol
lock is activated.
> For h = brightness,
press the Up/Down button to select
h1 = minimum to
h5 = maximum brightness and acknowledge with
the
button.
> For b = NaturaFresh temperature,
press the Up/Down button to select from
b1 = lowest to
b9 = highest setting and acknowledge with the
button. The altered NaturaFresh temperature adjusts
slowly to the new value.
Note: b5 = factory setting. By decreasing the temperature, b4
to b1, minus temperatures can be reached and the food in the
NaturaFresh compartment will freeze slightly.
Exiting set-up mode:
• Exit the set-up mode by pressing the On/Off button
2 min. the electronic system switches over automatically. The
normal operating mode is activated again.
5
button
is lit, the child-proof
; after
3
Publicité
Table des Matières
