Air Intake - Rizzoli X Basic Manuel D'utilisation

NO
Picture 15 - Examples of correct and incorrect connection of the chimney.
2.13 AIR INTAKE
The standard installation of the stove considers
that the oxidising air is taken directly from the
room where the stove is installed. In this case,
in the room must be always ensured the recycle
of fresh air, in particular if the room is small and
window and door frames are hermetic. The cor-
rect flow of air in the room must be ensured also
in presence of other combustion based devices,
aspiring hoods, chimneys and vent-holes. The air
intake in the room must have a minimum surface
of 80 cm2. On demand, Rizzoli can give specific
valves which can allow the automatic opening of
the air intake only when it is necessary for the
Picture 16 - Installation with air intake in the room of installation and installation with air intake directly
connected to the stove.
NO NO
correct working of the stove, in order to warrant
a maximum depression of 4 Pa in the place of in-
stallation.
The wood fired stove can also be connected so
that the oxidising air comes directly from outside.
In this way, for the stove it is not necessary anoth-
er air intake in the room of installation. To make
this it is necessary to prepare a conduct connected
directly with the external part of the house and
make a direct connection with the air intake of the
stove. The air intake of the stove is located in the
lower part. For the connection, we suggest to use
a flexible pipe.
79
YES