Ryobi FVG65 Manuel D'utilisation page 5

WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this product for the following purpose:
„ Light-duty vacuuming of dry surfaces
INSTALLING/REMOVING BATTERY PACKS
See Figure 1, page 7.
NOTE: This product cannot be used with one battery pack,
two must be used.
To install:
„ Press the battery cover release button and slide cover
off to remove.
„ Insert the battery packs into the product as shown.
„ Slide the battery cover back on until it clicks in place.
NOTE: Do not attempt to use this product if the battery
cover is not securely closed.
To remove:
„ Press the battery cover release button and slide the cover
off to remove.
„ Remove the battery packs from the tool.
For complete charging instructions, see the operator's manual
for your battery pack.
OPERATION
LED LIGHT FUNCTIONS
See Figure 2, page 7.
When two charged battery packs are installed in the tool,
the LED light will indicate the status of the tool when the
tool is powered on.
TOOL STATUS
MAX Mode
Startup Mode
Battery Level > 25%
Battery Level < 25%
Low Battery
Over Temperature
Vacuum Clogged/Jammed
STARTING/STOPPING THE VACUUM
See Figure 2, page 7.
„ Fully depress the on/off button to start and stop the motor.
NOTE: Press MAX button for MAX mode.
INSTALLING ACCESSORIES
See Figure 3, page 7.
Install only accessories designed for use with this vacuum.
„ Remove the battery packs.
„ Insert the dust brush, upholstery brush or crevice tool into
the vacuum suction port on the bottom of the vacuum
and push securely into place.
„ Insert the dust brush or upholstery brush on the end of
the crevice tool and push until the button engages.
„ When not in use, remove and store accessories in the
onboard storage area.
EMPTYING THE DUST CUP
See Figure 4 - 5, page 8.
The dust cup should be checked, emptied, and cleaned
periodically for maximum dust collection.
„ Remove the battery packs.
„ Hold unit over waste receptacle to keep debris from spill-
ing out onto other surfaces.
„ Press the dust cup release button then slide the dust cup
out to remove it from the vacuum.
NOTE: As the dust cup is removed, a gasket slides across
pre-filter to clean and collect debris in dust cup.
„ Empty contents of dust cup into waste receptacle by
shaking lightly or tapping sides to dislodge debris.
„ Replace dust cup by sliding along rail until the dust cup
release button engages.
5 — English
LED LIGHT SCENARIO
2 LED
1 LED
Solid Green (No Flashes)
Solid Red (No Flashes)
Flashing Red (3 Flashes)
Flashing Red (9 Flashes)
Flashing Red (12 Flashes)