Trotec FS 200 Traduction De La Notice Originale page 17

Transport and storage
Notice
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before transporting the device, proceed as follows:
• Before transporting the device, remove the fluid canister,
see chapter Exchanging the canister.
• Transport the canister separately.
• Fold the canister holder up for transport, see chapter
Folding the holder up.
• Only transport the device by use of the transport handle.
EN
Folding the holder up
23
22
1. Remove the safety bolt (20).
2. Fold the holder's stabiliser (21) in until it is located at the
same height as the lower holder (22).
3. Fold down the upper holder (23) until it abuts the housing.
24
4. Fold up the lower holder (22) until it abuts the housing as
well.
5. Then put the safety bolt (20) back to fix the holder in place.
6. Wind the power cable up on the foot (24).
Storage
When the device is not being used, observe the following
storage conditions:
• dry and protected from frost and heat
• protected from dust and direct sunlight
• with a plastic cover to protect it from invasive dust, if
necessary
• at the temperature specified in the technical data
• The ground is protected against possibly dripping fluid
residues.
Fog and flue gas simulator FS 200
20
21
20
21
B - 17