Troubleshooting; Specifications - Sony CDP-CE545 Mode D'emploi

Additional Information

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
,Check that the player is connected securely.
,Make sure you operate the amplifier correctly.
,Adjust the output level using the ANALOG
OUT LEVEL +/– buttons on the remote.
The CD does not play.
,There's no CD inside the player ("–NO DISC–"
appears). Insert a CD.
,Place the CD with the label side up on the disc
tray correctly.
,Clean the CD (see page 27).
,Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 27).
,Place the CD in the correct position on the disc
tray.
The remote does not function.
,Remove the obstacles in the path of the remote
and the player.
,Point the remote at the remote sensor
player.
,Replace all the batteries in the remote with new
ones if they are weak.
,Set the CD 1/2/3 switch on the remote
according to the command mode of the player.
The player functions incorrectly.
,The microcomputer chips may be operating
incorrectly. Turn the power off, then turn it
back on to reset the player.
GB
28

Specifications

Compact disc player
Laser
Laser output
Frequency response
Dynamic range
Harmonic distortion
Output
Jack
type
ANALOG OUT Phono
jacks
DIGITAL OUT Optical
(OPTICAL) output
connector
PHONES Stereo
phone jack
General
on the
Power requirements
Where purchased
Canada
Europe and some Asian
countries
Other countries
Power consumption
Dimensions (approx.)
(w/h/d)
Mass (approx.)
Supplied accessories
See page 4.
Design and specifications are subject to change without notice.
Semiconductor laser (λ = 780 nm)
Emission duration: continuous
Max 44.6 µW*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
2 Hz to 20 kHz ±0.5 dB
More than 93 dB
Less than 0.0045%
Maximum Load
output impedance
level
2 V Over 10 kilohms
(at 50 kilohms)
–18 dBm Wave length: 660 nm
10 mW 32 ohms
Power requirements
120 V AC, 60 Hz
220 V - 230 V AC, 50/60 Hz
110V - 120 V or 220 V - 240 V AC,
adjustable, 50/60 Hz
11 W
430 × 110 × 398 mm
(17 × 4 3/8 × 15 3/4 in.) incl. projecting
parts
5.1 kg (11 lbs 4 oz.)