Mennekes AMTRON WALLBOX Instructions D'installation page 9

Masquer les pouces Voir aussi pour AMTRON WALLBOX:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
3 Installation
Fig. 2: Mounting of stainless steel column
For mounting, MENNEKES recommends threaded bolts and nuts both made of stainless steel with a strength class of at
least 8.8. Use only threaded bolts and nuts made of stainless steel to prevent corrosion.
A separate supply line should be provided for each AMTRON® charging station.
Create bedplate using six threaded bolts M10
A
the prefabricated bedplate" on page 6. Cable length from top edge of bedplate approx. 2.5 m!
Alternatively, a prefabricated bedplate can be purchased directly. Please refer to Page <dg_ref_source_iline>Bestellinfos
Fundament</dg_ref_source_inline>.
Remove bolts
on the base plate; use the supplied bit insert for this purpose. Slide cover
B
2
Set the stainless steel column on the bedplate. Feed connection cable
C
uppermost cable outlet of the stainless steel column.
Bolt stainless steel column down using six VA nuts M10 and tighten using a torque wrench (tightening torque depends
D
on selected threaded bolt size).
If necessary, integrate the stainless steel column into the equipotential bonding / earthing system. A connection point is
provided on the stainless steel column's base plate for this purpose.
in accordance with the measurements shown on Page "Information on
1
4
upwards.
3
into the stainless steel column and out of the
EN
3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

18559

Table des Matières