shark AERON Mode D'emploi page 12

INTERIOR ASSEMBL
1 & 2 - Slip the liner into the helmet. Be
sure to reinsert it in the right direction.
Replace the front of the liner. Clip the
five clips into their housings. Start with
the central clip, sliding it over the arrow
marked on your liner support, then do the
next four side clips one by one.
3 to 5 - Reposition the rear of the liner.
Reposition each of the two attachment
snaps of the liner on one side then the
other facing their housing then press to
attach them. Make sure that the liner is
properly repositioned and tight from the
front to the back of the helmet.
12
2
4
1
3
5