Publicité
Press the Extra Freeze button to deactivate
the function before it automatically ends.
3.7 High temperature alarm
When the temperature in the freezer
compartment increases, the alarm indicator
flashes, the freezer temperature indicator
shows blinking H° and the sound is on.
To deactivate the alarm, press any button.
The alarm indicator and sound turn off. The
freezer temperature indicator shows H° for 5
sec before indicating the freezer temperature
again.
The alarm restarts 1 h after deactivation
until the normal conditions are restored.
If you do not press any button, the sound
switches off automatically after 1h.
3.8 Door open alarm
The door open alarm indicator turns on with
the sound if the fridge door is left open for 5
min. or if the freezer door is left open for 80
sec.
The alarm stops after closing the door. Press
any button to switch off the sound.
If you do not press any button, the sound
switches off automatically after 1 hour.
3.9 Setting mode
The Setting mode allows you to enable or
disable the ECOMETER indicator, to reset
the appliance factory settings and to change
the temperature units from °C to °F.:
Activating the Setting mode
1. Press and hold the ECO button for
approx. 3 sec. The display shows blinking
.
2. Once the Setting mode is switched on,
the display shows
Press and hold the ECO button for approx. 3
sec to deactivate the Setting mode.
The Setting mode deactivates if you do not
interact with the control panel for 60 sec.
Navigating the Setting mode
Tap the fridge temperature button to change
the parameter. Tap the freezer temperature
button to change the parameter value.
Display
ECOMETER indicator
In order to switch the ECOMETER on or off:
1. Activate the Setting mode.
2. Tap
3. Exit the Setting mode.
Button sounds
To enable or disable the sounds:
1. Activate the Setting mode.
2. Tap
3. Exit the Setting mode.
Temperature units
To change the temperature unit:
1. Activate the Setting mode.
2. Tap
3. Exit the Setting mode.
Factory settings
.
This function restores each setting to the
factory default settings. To restore the factory
default settings:
1. Activate the Setting mode.
until the display shows
the enabled or
for the disabled
ECOMETER indicator.
until the display shows
to switch the sounds on or off. The
indicator will change to
enabled or
for the disabled sounds.
until the display shows
. Tap the indicator showing the unit to
select between
for Celsius and
for Fahrenheit.
Default parameters
ECOMETER indicator
Button sounds
Temperature units
Factory settings
for
. Tap
for the
and
ENGLISH
9
Publicité
