GE RAK149P2A Manuel Du Propriétaire Et Instructions D'installation page 9

USING THE THERMOSTAT
ENTERING YOUR PROGRAM (cont)
Entering Heating Program (7-Day) NOTE: Run/Hold exits at any point
during programming.
1. Move the SYSTEM switch to HEAT
2. Press PROGRAM once. "Mon" (indicating weekday program) will
appear in the display. Also displayed are the current programmed start
temperature for the 1st heating period and the currently programmed
set time (flashing). This display window shows that for the 1st
weekday period, the start time is 6:00 AM, and 70° is the programmed
temperature (this example reflects factory preprogramming).
1st heating program period. Note that the time will change in 15 minute
increments.
4. Press PROGRAM once (the programmed temperature will flash). Press
5. Press PROGRAM once. The currently programmed start time and
setpoint temperature for the 2nd heating program period will appear.
6. Repeat steps 3 and 4 to select the start time and heating temperature
for the 2nd heating program period.
7. Repeat steps 3 through 5 for the 3rd and 4th heating program periods.
8. Press PROGRAM once. "Tue" (indicating Tuesday program) will appear
in the display, along with the start time for the 1st heating period and the
currently programmed temperature.
9. Repeat steps 3 through 7 to complete Tuesday heating programming.
10. Press PROGRAM once to change to Wed (Wednesday) heating
programming and repeat steps 3 through 7 to complete Wednesday
through Sunday programming.
11. When you have completed entering your heating program, press RUN/
HOLD to exit.
Entering Cooling Program (7-Day)
12. Move SYSTEM switch to Cool position
13. Follow Entering Cooling Program (7-Day) for entering your cooling
program using selected cooling times and temperatures.
14. To Exit Program press the RUN/HOLD button.
49-5000770 Rev. 1
9