VERITAS Florence Mode D'emploi page 86

1
1
1
Place the inner hoop on the fabric and press
firmly until them are securely fit to outer hoop
perfectly. If the inner hoop cannot fit properly,
loosen the outer hoop's fastening screw and
adjust until fitted.
When the fabric and inner hoop are
completely fit into the outer hoop, pull the
fabric from the four sides marked with the
arrows so that the fabric is stretched drum-
tight in the hoop, and then press the inner
hoop downwards so that it sinks into the outer
hoop a little and tighten the fastening screw.
①
Fastening screw
v Use the quick release device
If same type of fabric is used for embroidery,
open the quick release device under the outer
hoop.
Separate the inner hoop and outer hoop.
①
Quick release device
Place the inner hoop on the fabric and press
firmly until them are securely fit to outer hoop
perfectly, pull the fabric from the four sides
marked with the arrows so that the fabric is
stretched drum-tight in the hoop, and then
press the inner hoop downwards so that it
sinks into the outer hoop a little and close the
quick release device.
80