VERITAS Florence Mode D'emploi page 60

Lower thread error
The lower thread is broken or almost running out, please change and
refill the lower thread.
Please refer to "Winding the bobbin" and "Inserting the bobbin" chapters
for more information.
Motor overload protection
The motor is overloaded due to the jammed threads or the fabrics are
too thick to be penetrated.
Presser foot lifter – wrong position
Please check if the presser foot lifter is at the right position. To lower the
lifter when sewing and raise it while the embroidery hoop is resetting.
Buttonhole lever – wrong position
Please check if the buttonhole lever is at the right position. To raise the
lever in normal use and lower the lever while sewing buttonhole.
Needle position – wrong position
After installing the straight stitch plate, if the needle position is in a lower
position, turn the handwheel backwards you to bring the needle to the
highest position.
Screen
Embroidery hoop is not installed or should be removed
Straight stitch plate is not installed
Please refer to "Replacing the needle plate" chapter for more information
The router cannot connect with the wifi. Please check the wifi
service
The connection failed because the router might not be in operation or the
password is not correct.
A.If it was the first time for setting, please check if the password is
correct.
B.If the router mode had already been set up successfully, please check
if the router works normally and is well connected.
** Please refer to PDF instruction file or operation Video in MyPatterns App.
If the problem is still not solved, please contact your local dealer.
Embroidery mode
54 54 54
56-58
**
**
**
-
Page
**
65
84