Publicité
contact. These types of con-
nections may overheat and
cause fire..
• Place the power cable and
hoses (if any) of the product
so that they shall not cause a
risk of tripping over.
• Penetration of humidity and li-
quid to live parts or to the
power cord may cause short
circuit. Thus, do not use the
product in humid environ-
ments or in areas where water
may splash (e.g. garage, laun-
dry room, etc.) If the refriger-
ator is wet by water, unplug it
and contact an authorized ser-
vice.
• Do not ever connect your refri-
gerator to power saving
devices. These systems are
harmful for the product.
• There is a risk of contact with
electrical parts when removing
the electronic board cover and
the compressor rear cover (if
fitted). Do not remove the elec-
tronic board cover and the
compressor rear cover (if fit-
ted). There is a risk of electro-
cution!
1.7
Operational Safety
• Do not ever use chemical
solvents on the product. These
materials contain an explosion
risk.
• In case of a failure of the
product, unplug it (or de-ener-
gise the fuse to which it is con-
nected), and do not operate
until it is repaired by the au-
thorized service. There is a risk
of electric shock!
• Do not place flames (lighted
candle, cigarette, etc.) or heat
sources (iron, hob, oven, etc.)
on or near the product. Do not
place flammable/explosive
materials near the product...
• Do not get on the product. Risk
of falling and injury!
• Do not cause damage to the
pipes of the cooling system us-
ing sharp and piercing tools.
The refrigerant that sprays out
in case of puncturing the gas
pipes, pipe extensions or upper
surface coatings may cause ir-
ritation of skin and injury to the
eyes.
• Do not intervene in or damage
the coolant circuit Risk of ex-
plosion.
• Do not place and operate elec-
trical appliances inside the re-
frigerator/freezer unless it is
advised by the manufacturer.
• Do not use any procedures
other than those recommen-
ded by the manufacturer to
speed up defrosting.
EN / 9
EN
FR
IT
PT
Publicité
