Publicité
• Before starting the installation,
switch off the fuse to de-ener-
gise the power line to which
the product is connected.
• The product should be in-
stalled by two or more people.
Use protective gloves while re-
moving the product from the
packaging and installation.
• This product is designed for
use at a maximum altitude of
2000 metres above sea level.
• Keep children away from in-
stallation area.
• Check for any damage on the
product before installing it. Do
not have the product installed
if it is damaged.
• Always use personal protective
equipment (gloves, etc.) during
product installation, mainten-
ance and repair. Risk of injury.
• Do not install or leave the
product in places where it may
be exposed to external ambi-
ent temperatures.
• Place the product on a clean,
level and hard surface and bal-
ance it with the adjustable legs
(by rotating the front feet to
the right or left). Otherwise, the
refrigerator may tip over and
cause injuries.
• Proceed with care to prevent
causing any damage to the
floors (tiling etc.) while moving
the product. Install the product
on a floor, or provide sufficient
support depending on the size,
weight and the use-case of the
product. Ensure that the
product is not near a heat
source, and all four feet are
stable and leaning against the
floor. Install the product as ne-
cessary, and ensure that it is
horizontal, using a bubble
level. To ensure the complete
efficiency of the refrigerant cir-
cuit, wait for at least two hours
before operating the product.
• The product shall be installed
in a dry and ventilated environ-
ment. Do not keep carpets,
rugs or similar covers under
the product. This may cause
risk of fire as a result of inad-
equate ventilation!
• Do not block or cover ventila-
tion holes. Otherwise, power
consumption increases and
your product may be damaged.
• Leave sufficient space by the
sides and above to ensure ad-
equate ventilation. The gap
between the back panel and
the wall behind the product
must be a minimum of 50mm
in order to prevent hot sur-
faces. Reducing this distance
may increase the energy con-
sumption of product.
EN / 7
EN
FR
IT
PT
Publicité
