Publicité
• In case that multiple options are present,
glass shelves must be placed so that the
air outlets at the rear wall are not blocked
and preferably, in a way that air outlets
remain below the glass shelf. This com-
bination may help improving air distribu-
tion and energy efficiency.
• Using the below drawer when storing is
strongly recommended.
• For optimum performance, Quick Freez-
ing can be used (if available), 24 hours
prior to placing fresh foods in the freezer.
• In most cases, 24 hours is enough for the
Quick Freezing function after fresh foods
are placed in the freezer. After some
time, Quick Freezing function will deactiv-
ate automatically.
• Caution: When freezing a small amount
of food, Quick Freezing function can be
deactivated after some time to ensure
energy saving.
• Depending on the product's features; de-
frosting frozen foods in the cooler com-
partment will ensure energy saving and
preserve food quality.
• In order to load the maximum quantity of
food into the freezer compartment of
your refrigerator, the upper drawers
should be taken out and the food should
be placed onto the wire/glass shelves.
• Make sure the foods are not in contact
with the cooler compartment temperat-
ure sensor described below.
• If they are in contact with the sensor, en-
ergy consumption of the appliance might
increase
• Food shall be stored using the drawers in
the cooler compartment in order to en-
sure energy saving and protect food in
better conditions.
• Food packages shall not be in direct con-
tact with the temperature sensor located
in the freezer compartment.
6.2 First Use
Before using your refrigerator, make sure
the necessary preparations are made in line
with the instructions in "Safety and Environ-
mental Instructions" and "Installation" sec-
tions.
• Wait for at least 2 hours before operating
the product, to ensure the complete effi-
ciency of refrigeration.
• Keep the product running without placing
any food inside for 6 hours and do not
open the door, unless absolutely neces-
sary.
• The temperature change caused by open-
ing and closing of the door while using
the product may normally lead to con-
densation on door/body shelves and
glassware placed in the product.
A sound will be heard when the
compressor is engaged. It is nor-
mal for the product to make noise
even if the compressor is not run-
ning, as fluid and gas may be com-
pressed in the cooling system.
It is normal for the front edges of
the refrigerator to be warm. These
areas are designed to warm up in
order to prevent condensation.
For some models, indicator panel
turns off automatically 1 minute
after the door closes. It will be re-
activated when the door is opened
or any button is pressed.
EN / 18
EN
FR
IT
PT
Publicité
