SilverCrest SDMF 1300 B2 Manuel D'utilisation page 28

Connect the power plug
power socket. Set the on/off switch
I position.
LED
11 ] [
Flashing (blue)
Continuously on
(blue)
Ejecting steam: Push in
m WARNING! Risk of burns!
When steam smoothing, always point the
steam nozzles
1 ] [
(Fig. F).
Never steam smooth clothes while they are
being worn.
Allow the clothes to cool down on a clothes
hanger before wearing them.
Slightly stretch the clothes with one hand.
Steam smooth the clothes by moving over
them with the brush
away from the steam.
Apply light pressure on the clothes with the
brush . Move the brush back and forth in
[ 2 ]
a straight line.
NOTES:
After washing: Hang up the clothes (e.g. on
a clothes hanger). The clothes thus dry with
fewer creases.
The product cannot produce strong creases
or a smooth, ironed appearance. For such
needs, an iron is more suitable.
While steam smoothing: The clothes absorb
moisture. Allow the clothes to dry completely
before storing them in your wardrobe.
Continuous steam operation
During continuous operation, hot steam exits out
of the steam nozzles
1 ] [
pressing in .
3 ] [
Continuous steam operation
Start continuous
Press in
operation
Move down the lock
Stop continuous
Move up the lock
operation
24 GB/IE
to a suitable
8 ] [
to the
[ 12 ]
Description
Product warming up
Product ready for
steam smoothing
.
3 ] [
towards the clothes
. Keep your hands
2 ] [
without the need to keep
.
[ 3 ]
3 ] [
.
3 ] [
If water drips out of the steam nozzles
Pull up the lock
products heats up now.
NOTES:
When the water tank
continuous steam operation, the product
turns off automatically after approx.
40 seconds. The red LED
. Fill water into the water tank (see
[ 3 ]
"Filling the water tank").
The product turns back on automatically
when the steam button
˜ Steam smoothing curtains
and upholstery
Remove creases and wrinkles from curtains
and upholstery by hanging these over a
railing and then tightening them.
Before steam smoothing: Always carry out a
test on an inconspicuous piece of the fabric.
Steam the curtains/upholstery (see "Steam
smoothing clothes").
When using the product horizontally: Hold
the product vertically from time to time to
maintain the maximum steam power.
˜ Stop steam smoothing
Move up the lock
.
3 ] [
Place the product, with its base
and stable surface.
Set the on/off switch
Disconnect the power plug
power socket.
NOTE: When
stops heating automatically after approx.
15 minutes and red LED
Let the product cool down (for approx.
15 minutes). Do not leave the product
unattended while it is still hot.
Empty the water tank
prevent limescale (see "Filling/draining the
.
water tank").
. Release . The
3 ] [ [ 3 ]
is emptied during
5 ] [
flashes. Release
[ 11 ]
is pressed.
3 ] [
, if applicable. Release
[ 3 ]
, on a flat
[ 6 ]
to the O position.
12 ] [
from the
8 ] [
is released, the product
3 ] [
flashes.
11 ] [
after each use to
5 ] [
:
1 ] [