Use The Gun; Change The Nozzle - GreenWorks GPW2000 Manuel De L'utilisateur

EN
When you operate the self-coiling hose, make sure that the
hose has no blockage.
• The water supply must come from the water main
• Do not use hot water
• Do not use water from ponds or lakes
Do the local regulations when you connect the garden hose
to the water supply. Direct connection through a receiver
tank or backflow preventer is usually permitted.
Inspect the filter in the water inlet connector before you
connect the garden hose
• If the filter is damaged, do not use the machine until the
filter is replaced.
• If the filter is dirty, clean the filter.
1. Uncoil the garden hose (18).
2. Let the water flow through the garden hose (18) for 30
seconds.
3. Turn the water supply off.
4. Install and tighten the end of the garden hose (18) to the
water inlet connector (5).
There must be a minimum of 3 m of free hose between the
water inlet and the water supply.
WARNING
WARNING
WARNING
CAUTION
5
18
CAUTION
English
4.2

USE THE GUN

25
For safe control, keep your hands on the gun at all times.
• Pull and hold the gun trigger (19) to start the machine.
• Release the gun trigger (19) to stop water flow through
the nozzle.
4.2.1 UNLOCK THE GUN TRIGGER
• Push backward the trigger safety button (25).
4.2.2 LOCK THE GUN TRIGGER
• Push forward the trigger safety button.
4.3

CHANGE THE NOZZLE

Before you change the nozzle:
1. Pull the gun trigger to release water pressure.
2. Lock the trigger safety button on the gun.
3. Stop the mahcine.
Do not point the spray wand at your face or others'.
8
WARNING
WARNING
WARNING