Fiche D'identification De L'equipement; Fiche D'inspection - Neofeu Neo Inox Manuel D'instructions

• Rappel de la longe : Le rappel de la longe doit avoir lieu sans
freinage quel que soit le niveau de déroulement de la longe.

FICHE D'IDENTIFICATION DE L'EQUIPEMENT #8

1. Fabricant, 2. Produit, 3. Type, 4. Numéro de série, 5. Date
de production, 6. Date d'achat, 7. Date de 1ère utilisation.
Ce produit est conforme au Règlement 2016/425. Il répond aux exigences de la norme harmonisée EN360 : 2002. La
déclaration de conformité est disponible sur : www.neofeu.com.
Organisme notifié pour l'examen UE de type : Apave SA (n°0082) - 6 Rue du Général Audran - 92412 COURBEVOIE cedex
- France.
Organisme notifié intervenant dans la phase de contrôle de la production : AFNOR CERTIFICATION (N°0333) - 11, rue Francis
de Pressensé - FR 93571 LA PLAINE SAINT DENIS Cedex.
TABLE KEY #1.1 - #1.2
Model
1. Lanyard type: C = Steel cable; I = Stainless steel; D = Dyneema
strap; E = Polyester strap; SA = Energy absorber with a polyamide
and polyester tear strap, 2. Lanyard length in metres : Minimum
and maximum length of each model, 3. Lanyard cross-section:
Diameter of the cable or width of the strap in mm, 4. Housing
material: P = Plastic; S = Steel; AL = Aluminium, 5. Fall indicator:
T1 = Fall indicator integrated to the connector; T2 = Fall indicator
integrated to the end of the lanyard, 6. Swivel hook: E1 = Optional
swivel hook on connector; E2 = Swivel hook on daisy chain
connector; E3 = Swivel hook on securing ring; E4 = Swivel hook
on connector and securing ring, 7. Capacity (kg/lb) : Maximum
weight of the equipped user, 8. Clearance (m) Vertical: Required
distance from the ground in metres below the user's feet, 9.
Horizontal use : YES or NO. If so, refer to Horizontal use specific
paragraph, 10. Horizontal minimum clearance (m) : Required
distance from the ground below the user's feet in the specific
case of horizontal use, 11. Integrated rescue : Retractable type
fall arrester with integrated rescue system. If so, refer to specific
paragraphs, 12. Use of factor 2: YES or NO, 13. Clearance for
use of factor 2 (m): Floor clearance required under the user's
feet especially when using factor 2, 14. Normative references:
References to the standards and technical specifications used,
15. Use in inverted position: YES or NO. If so, the SRL block can
be connected directly to a fall arrest point on the harness.
FALL ARRESTER MARKING #2
(a) Ref: product reference, (b) Manufacturer's identifier, (c) S/N:
Serial number (Manufacturing date – Manufacturing batch), (d)
Bar code, (e) Product standard, (f) Contact address, (g) Date of
manufacture, (h) Cable/webbing length.
PICTOGRAMS OF USE #3
(1) Pre-use visual inspection, (2) Do not release the lanyard.
Ensure that the lanyard is secure before use; (3) Use the
authorised anchor on the fall arrester harness, (4.A) Maximum
weight authorized at 100 kg, (4.B) Maximum weight authorized at
140 kg, (5) Usable anchor point, (6) Restrict the pendulum effect.
(7) Do not use above movable materials, (8) Do not load the cable
reel on an edge, (9.A) Horizontal use tested, (9.B) Do not employ
for a horizontal use – Use only vertically, (10) Do not modify the
device, (11) Temperature of use, (12) Store in a protected area,
(13) Dated label, (14) CE Marking / Notified body no, (15) Follow
the instructions for use, (16) Tested in configuration factor 2.
WARNING
Medical Conditions

FICHE D'INSPECTION #9

(1) Date, (2) Motif, (3) Contrôleur, (4) Remarque, (5) Résultat
du contrôle: a. Apte, b. À contrôler, c. Inapte, (6) Prochaine
inspection.
Given the fall hazards associated with work at height, it is
necessary to remind that only people in good health and physical
condition can participate. Work at height requires concentration,
thus are excluded people subject to vertigo, agoraphobia, under
medication including tranquillizers, or under the influence of
alcohol or drugs.
If any doubt, consult your GP before working on height.
In the event of a fall, it is important to keep your self-control, not
to panic so as to limit as much as possible harmful issues, and to
avoid further accident.
Training and competence.
This device must be used by a competent and trained person, or
under the direct visual control of a competent person aware and
capable to take care of the user's safety. It is compulsory to know
and follow the instructions of this manual.
Rescue plan.
Before operation, a rescue plan must be in place in case of
emergency. A person subject to fall hazards must not remain
alone. People around must be able to rescue him without
delay and without further accident. It is recommended to have
an extra fall arrester in perfect serviceable condition in case of
emergency.
DESCRIPTION
This self-retracting fall arrester complies with the EN 360:2002
standard.
This device is meant to arrest accidental falls of an individual
with its instantaneous locking function. It is equipped with an
internal energy dissipation system that makes it safer and more
comfortable to use.
This fall arrester is made up of a casing that protects the
mechanism, an anchor point, a self-retracting lanyard equipped
with an automatic locking connector EN 362, and an identification
plate that also serves as a reminder for the proper use of the
device.
This fall arrester allows an individual to work safely in any type of
activity at heights, i.e. on roofs, scaffolding, vertical structures, etc.
where there is a risk of falling.
The maximum weight of the user indicated in the device
characteristics (including the user's equipment) must not be
exceeded (#1-7).
USE OF THE EQUIPMENT
- The device must be used for the only purpose it is intended for.
It is forbidden to modify it or use it for any other purpose.
- This device is personal equipment. It is limited to one person
and must be individually assigned so as to ensure good care
is taken of it.
9