Publicité
work. The temperature controller will automatically control the working
state of compressor solenoid valves, fans and other components according
to the set control parameters.
(4) Since the restart of the compressor and other components takes a long
time, depending on different conditions, the time varies from a few seconds
to a few minutes, so do not turn off the power frequently and turn it on
again.
⑥.ADJUST THE TEMPERATURE CONTROLLER PARAMETERS.
CW-5000/5200 series uses intelligent thermostats. Usually the user does
not need to adjust it. If it is really necessary. See "Operating status and
parameter tuning".
(1) The display board can display six digits and nine status indicators
(compressor-comp, solenoid valve-solenold valve, electric heating
⑤.CHECK THE WATER LEVEL IN THE TANK.
The first start of the new cooler drains the air in the
water pipe, causing a slight drop in the water level,
but in order to maintain the water level in the green
area, it is allowed to add enough water again. Please
observe and record the current water level, check
again after the chiller has been running for a period of
time, and if the water level drops significantly,
please re-check the leakage of the water pipe.
DISPLAY PANEL AND BUTTONS
- 6 -
Publicité
