Publicité
Warning-To reduce the risk of injury, user must read instructions
manual carefully.
1. PLEASE MAKE SURE THAT THE POWER SUPPLY AND THE
POWER OUTLET ARE IN GOOD CONTACT AND THE GROUNDING
WIRE MUST BE FIRM!
Although the average working current of the chiller is small, the instantaneous
working current can sometimes reach 6~10 amperes (the instantaneous working
current of the AC110V power supply model is possible up to 10~1 5 amperes)
2. PLEASE MAKE SURE THAT THE WORKING CHILLER HAS A
STABLE AND NORMAL VOLTAGE!
Since the refrigeration compressor is more sensitive to power supply and voltage,
so the working voltage our standard product is 220^ 240V (110V model is 110
120V), if you really need a wider operating voltage range, we can customize.
3. PLEASE MISMATCHED POWER FREQUENCY WILL CAUSE
CHILLER DAMAGE!
Please select mode: 50Hz or 60Hz depending on the actual situation.
4. TO PROTECT THE PUMP, IT IS STRICTLY FORBIDDEN TO RUN THE
CHILLER WITHOUT WATER IN THE STORAGE TANK!
The new machine is packed after draining the entire water in the tank, so please
make sure that the tank has enough water and there is water inside the machine
before starting, otherwise it is easy to damage the pump.
When the water level is below the green (normal) range of the water level gauge,
the cooling capacity of our chillers will drop slightly. Therefore, make sure that the
water level is in the green (normal) range. Pumps are strictly forbidden by
circulating drainage!
5. PLEASE MAKE SURE THE AIR INLET AND OUTLET ARE WELL
VENTILATED!
The air outlet from the obstacle to the back of the cooler must be at least 30 cm,
and it should be at least 8 cm between the obstacle and the side air intake.
WARN
- 2 -
Publicité
