SilverCrest SLSA 3.7 A1 Instructions D'utilisation page 21

Wipe the product lightly with a damp cloth. If required, use some mild
detergent on the cloth. Then wipe it with a dry cloth and ensure that the
appliance is completely dry before the next use.
Cleaning with the cleaning brush
Switch the product off using the On/Off button
, , is attached on the product, remove it before cleaning as
10 11 12
described in the chapter "Changing the attachments". Remove the
shaving head attachment
both sides.
Use the cleaning brush
and the area behind the shaving head attachment
Cleaning with running water
Switch the product off using the On/Off button
USB-C-connector of the USB-A to USB-C charging cable
tachment ,
2 10
cleaning as described in the chapter "Changing the attachments".
Wash the shaving head attachment
under running water.
Allow all parts to dry thoroughly.
Use the enclosed cleaning brush
trimmings from inside the product housing.
Storage
To store the product, always put on the shaving head cover
shaving head attachment
If you are not using the product for extended periods, store it in the
storage bag .
8
Store the product in a clean, dust-free and dry place.
by pressing the release button
2
to clean the shaving head attachment
9
, , is attached on the product, remove it before
11 12
.
2
5
2
5
and the attachments
2
to remove any remaining hair
9
. If the attachment
from
3
2
(inside the housing).
or disconnect the
. If the at-
7
, ,
10 11 12
on the
1
GB/IE/NI 21