Crivit HG12773 Instructions De Montage Et Consignes De Sécurité page 11

If using gas or other combustion appliances
additional ventilation will be required.
Make sure that the vents on the side of the
inner tent are not covered at any time.
Do not leave children unattended in the tent.
WARNING! Do not use high voltage
appliances or hot appliances in the tent,
as this may cause fire or electric shock.
˜ Fire precautions
Camp safely. Follow these common sense
rules:
Do not place hot appliances near the walls,
roof or curtains.
Always observe the safety instructions for these
appliances.
Never allow children to play near hot
appliances.
Keep exits clear. Do not block the exit with
objects.
Make sure you know the fire precaution
arrangements on the site.
˜ Tent assembly
Please ensure that the product is only
assembled by people with the appropriate
skills.
Note: The polyester material of the tent
consists of water-repellent material.
It is possible that during the first rainfall the tent
will not be completely watertight. However, the
threads of the tent will contract when exposed
to water so that after a short time the tent will
become watertight.
Do not pitch the tent on a sloping ground.
Erect the product in accordance with the
illustrations A to F.
10 GB/IE
Illustration A:
1. Remove the tent and all accessories from the
retail pack.
2. Lay the inner tent with PE floor
completely unfolded on the ground. The
opening for the poles must be on the outside of
the inner tent with PE floor.
3. Unfold the poles and assemble the individual
parts together one at a time.
4. Fix each end loop with a peg
ground.
Illustration B:
5. Lift the tent and guide the poles
the pins provided on the ground. The frame is
now set up and under tension. Avoid over-
tensioning. If the tension is too high, the tent
may tear.
6. Attach the pole clip to the poles.
Illustration C:
7. Guide both ends of top pole
pockets which on the top of inner tent with PE
floor.
8. Tie up the top of inner tent with PE floor to the
poles and top pole
[ 3 ]
Illustration D:
9. Unfold the outer tent and cover the inner tent
with PE floor.
10. Attach the outer tent
with PE floor by using fabric loops which
1 ] [
underneath the outer tent.
Illustration E:
11. Fix all loops from the outer tent to the ground
with pegs
.
5 ] [
Illustration F:
12. Fix all guy ropes to the ground with pegs
13. You can now use the tent.
flat and
[ 1 ]
in the
5 ] [
into
3 ] [ 4 ] [
into the
4 ] [
.
[ 4 ]
to the inner tent
2 ] [
5 ] [
.