Add 30 Seconds Feature; Easy Minute Feature; Cancel; Clock - Whirlpool YGH5184XP Guide D'utilisation Et D'entretien

Add 30 Seconds Feature

Cook time may be added to a manual cook cycle by touching the
ADD 30 SEC. (START) pad. Touching ADD 30 SEC. during the
cycle will add 30 seconds of cook time at the current cook power.
Each additional touch adds 30 seconds of cook time.
The ADD 30 SEC. pad will also start the microwave oven at 100%
power for 30 seconds after the door is closed or CANCEL is
touched. Additional time may be added by touching
ADD 30 SEC.

Easy Minute Feature

The numerical pads 1-5 share function with the Easy Minute
controls. When one of these controls is touched (while no
function is operating), the microwave oven will begin cooking at
high power for 1-5 minutes, depending on which pad is touched.
After cooking begins, the Easy Minute controls return to their
normal numerical pad function.
The CANCEL pad stops most functions except for the Timer,
Control Lock and Demo Mode.
The microwave oven will also turn off when the door is opened.
Close the door and touch START control to resume the cycle. A
sensor cooking cycle may not be resumed if interrupted by
opening the door.
This is a standard 12-hour clock (12:00-11:59) and does not
show a.m. or p.m.
To Set:
The microwave oven and timer must be off.
1. Touch CLOCK.
2. Touch the number pads to set the time of day.
3. Touch CLOCK or START.
To Remove:
1. Touch CLOCK.
2. Touch 0.
3. Touch CLOCK.
The time will disappear, and ":" will appear on the display.
Tones are audible signals, indicating the following:
One tone
Valid entry (short tone)
End of Timer countdown (long tone)
Two tones
Reminder, repeat each minute after the end-of-cycle tones
End of stage in multistage cooking
Hidden feature has been entered or exited
Three tones
Invalid entry
Four tones
End of cycle

Cancel

Clock

Tones

To Turn Off Valid Entry Tones: Touch and hold the number pad
"1" for 5 seconds until 2 tones sound. Repeat to turn tones
back on.
To Turn Off All Tones (except end-of-Timer and hidden
feature signals): Touch and hold the number pad "2" for
5 seconds until 2 tones sound. Repeat to turn tones back on.
The Timer can be set in minutes and seconds, up to 99 minutes
99 seconds and counts down the set time.
NOTE: The Timer does not start or stop the microwave oven.
When the Timer is in use, the microwave oven can also operate.
To see the countdown for 5 seconds when the microwave oven is
in use, touch TIMER SET-OFF.
To Set:
1. Touch TIMER SET-OFF.
If no action is taken after 1 minute, the display will return to
the time of day mode.
2. Touch the number pads to set the length of time.
3. Touch TIMER SET-OFF or START.
If TIMER SET-OFF or START is not touched within 5 seconds,
"START?" will appear on the display. If TIMER SET-OFF or
START is not touched within 1 minute, the display will return
to the time of day mode and the programmed function will be
canceled.
When the set time ends, "END" will appear on the display and
1 tone will sound.
Touching CANCEL while a cook function is active in the
display will cancel the cook function, not the Timer.
4. Touch TIMER SET-OFF at any time to cancel the Timer.
The length of time can be changed during the countdown by
repeating the above steps.

Control Lock

The Control Lock shuts down the control panel pads to avoid
unintended use of the microwave oven. When the control is
locked, only the Vent Fan and Light pads will function.
To Lock/Unlock Control: The microwave oven and Timer must
be off. Touch and hold CANCEL for 5 seconds until 2 tones
sound and a lock icon appears in the display. Repeat to unlock
and remove the lock icon from display.

Vent Fan

The vent fan has 4 speeds ranging from 4 (fastest) to 1 (slowest).
Zero (0) is off.
To protect the microwave oven, if the temperature from the range
or cooktop below the microwave oven gets too hot, the vent fan
will automatically turn on at speed 4. It may stay on for up to
1 hour to cool the microwave oven. When this occurs, the vent
fan cannot be turned off.
To Turn Vent Fan On/Off: Repeatedly touch the VENT FAN
4 SPEEDS pad to cycle through the four speeds 4, 3, 2 and 1 and
off, 0. "FAN" and the selected number will appear on the display
for 2 seconds.

Cooktop Light

The cooktop light has 3 settings: on, night and off.
To Turn On/Night/Off: Touch the light pad repeatedly to cycle
through settings.

Timer

7