Publicité
Les langues disponibles
Les langues disponibles
FDS AMPLIFIERS
U s e r m a n u a l
CAUTION
In addition to this fuse near the battery, the FDS4.350 has an additional fuse which requires
installation near the amplifier.
Use the connector supplied with the fuse holder (fig. 6).
Crimp the power cable to the intended spade terminal.
Connect the connector to the amplifier by using the adequate spade terminal, then block the cable by
screwing tight.
Insert the fuse into the fuse holder(s), and screw tight.
3.7 – Start-up and checks
The connection phase is now complete. You must now check the power supply (is correct) and that
everything is working correctly (head unit/amplifier/speaker). Set the source gain to its minimum. Set
the gain on your amplifier to 1/3 of the way. Turn on the different elements. Once all the elements are
on, carry out a test at low volume.
CAUTION
FDS4.350 is working with a particular starting sequence. It needs both REM signal and audio
signal at the input to start correctly. Please, check audiosignal presence with sufficient vo-
lume on the head unit.
fig. 6
29
Publicité
