Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
HOW TO USE (CUTTING)
1. Normal cutting (Fig. 5)
(1) Turn the lever in the direction of the arrow mark
and open the cover.
(2) Set the setting dial at the "cut" position. (Turn
the setting dial all the way clockwise.) (Fig. 6)
(3) Set the unit in the position shown in Fig. 5.
(4) Set the rebar to be cut on the lower cutter.
(5) When the rebar is set, make sure that either the
reaction stopper B is hooked to the rebar.
(6) Pull the switch trigger and cut the rebar.
WARNING:
While turning switches, never put your hand close
to the cutter, reaction stopper, or bending roller.
Bringing your hand close to these components can
result in serious injury.
Do not cut any rebar exceeding the maximum
capacities of the unit described in the specifications.
Never cut any hard materials such as PC(Precast
concrete) steel, GRADE 60, etc. Materials of this
type are likely to scatter into pieces and cause
injuries.
The rebar you are cutting may have a hard spot in
it. Quality may vary within each rebar. Do not
attempt to cut NON-GRADE rebar.
Replace the worn grip rubber with new one when
replacing the cutter.
Note that the unit is not a hand held tool. Be
absolutely sure to use the unit only after placing it
on stable spots such as floor, ground, etc.
Only cut the one piece of rebar at a time. It is
impossible to cut more than two pieces at one
time, and attempting to do so can damage the unit
and blades.
CAUTION:
Even after the cutting has been completed, continue
pulling the switch trigger until the motor starts to
run in the reverse direction and the cutter starts to
return. If the switch trigger is released too early,
the cutter will not return and the trigger will have
to be pulled again.
14
Reaction stopper B
Bending
roller
Fig. 5
Adjusting position
Fig. 6
Fig. 7
Fig. 8
Rebar
Setting
dial
Publicité
Table des Matières
