Publicité
FUNCTIONAL PRINCIPLE
EN
After the SENSORSAFE clip has been installed on the seat and connected to the App, it will
communicate with your smartphone when it is closed. The LED on the clip will light up blue
when it successfully connects to the the CYBEX SensorSafe mobile app on your smartphone.
A red light indicates that the clip is not connected to the App.
The following information will be sent to the application by the closed clip, when connected
via Bluetooth:
• status of the clip (open or closed)
• ambient temperature around the clip
• battery status
Furthermore, SENSORSAFE will send alarms of possible unsafe situations. You will be
notified when:
• ambient temperature around the clip approaches a critical level (too high or too low).
• the clip has been buckled for more than two hours.
• the clip has become unbuckled.
• you leave a certain range around your car and the clip is still closed.
If you stay outside of range for too long and the clip is still closed, family emergency contacts,
that you designated in the App, will be notified. To ensure these crticial safety notifications
are received, please designate at least 2 family emergency contacts. You can find detailed
information about the CYBEX App on www.cybex-online.com.
The SENSORSAFE clip is designed to go into sleep mode after 12 hours to conserve battery
life. To wake it up, open the clip and buckle it again.
8
The SENSORSAFE clip should be stored in the unbuckled position while it is not in use to
1
conserve battery life.
REPLACING THE BATTERY
The CYBEX App shows the battery status of the clip. Also, the LED on the clip will flash
rapidly after closing when the battery is running low and the LEDs will not flash at all if the
battery is dead. Please replace the battery in time to be able to connect to SENSORSAFE.
To replace the battery please open the compartment located at the rear of the clip with a
Philips head screwdriver (9). Remove the circuit board and old battery. Insert a new CR2032
battery (10) and re-insert the circuit board into the chest clip with the battery facing up (11).
After changing the battery, you should be able to connect to the clip in the CYBEX Application.
Please consider the following when replacing the battery:
• Keep all batteries out of reach of children.
• Only use the recommended type CR2032 batteries (Panasonic or Energizer).
• An empty battery always must be removed in order to protect the product from escaping
liquids.
• Never expose this product or the battery to fire.
• Do not use old batteries or batteries that show signs of leakage or cracks.
• Only use high-quality new batteries.
• Pay attention to the correct polarity (+/–).
Publicité
