Maytag MGR8800FZ1 Instructions D'installation page 9

3. Use a 15/16" (2.4 cm) combination wrench and an adjustable
wrench to attach the flexible connector to the adapters.
IMPORTANT: All connections must be wrench-tightened. Do
not make connections to the gas regulator too tight. Making
the connections too tight may crack the regulator and cause
a gas leak. Do not allow the regulator to turn when tightening
fittings.
A
B
C
A. Gas pressure regulator
B. Use pipe-joint compound.
C. Adapter (must have 1/2"
(1.3 cm) male pipe thread)
D. Flexible connector
Complete Connection
1. Check that the gas pressure regulator shutoff valve is in the
"on" position.
A. Gas pressure regulator shutoff valve
shown in the "on" position
2. Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
A
A. Closed valve
B. Open valve
3. Test all connections by brushing on an approved
noncorrosive leak-detection solution. If bubbles appear, a
leak is indicated. Correct any leak found.
4. Remove cooktop burner caps and grates from parts
package. Place the burner bases as indicated by the
following illustration for your model:
For Models KFGG500E:
A
B
A. Medium (Semi Rapid) C. Medium (Semi Rapid) D. Small (Auxiliary)
B. Large (Ultra Rapid)
D
E
H
G
E. Manual gas shutoff valve
F. 1/2" (1.3 cm) or 3/4" (1.9 cm)
gas pipe
G. Use pipe-joint compound.
H. Adapter
A
B
D
C
E
E. Large (Ultra Rapid)
For Models MGR8800F and MGR8800H:
A
B
A. Medium (Semi Rapid)
B. Large (Ultra Rapid)
F
5. Burner caps should be level when properly positioned. If
burner caps are not properly positioned, surface burners will
not light. Place burner grates over burners and caps.
B
A
6. Place the burner caps on the appropriate burner bases.
IMPORTANT: The bottom of the small and medium caps are
different. Do not put the wrong size burner cap on the burner
base.
AUX
Small (Auxiliary)
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
7. Plug into a grounded 3 prong outlet.
8. Slide range into final location, making sure the rear leveling
leg slides into the slot of the anti-tip bracket.
C
C. Oval (OV) D. Small (Auxiliary)
E. Large (Ultra Rapid)
C
A. Burner base
B. Burner cap
C. Burner grate
SR
Medium (Semi Rapid)
Large (Ultra Rapid)
WARNING
Electrical Shock Hazard
D
E
UR
9