Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Burner Input Requirements
Input ratings shown on the model/serial/rating plate are for
elevations up to 2,000 ft (609.6 m).
For elevations above 2,000 ft (609.6 m), ratings are reduced at
a rate of 4% for each 1,000 ft (304.8 m) above sea level (not
applicable for Canada).
WARNING
Excessive Weight Hazard
Use two or more people to move and install range.
Failure to do so can result in back or other injury.
1. Remove shipping materials, tape and film from range.
2. Remove oven racks and parts package from inside oven.
3. Do not remove the shipping base at this time.
A
A.Shipping base
INSTALLATION INSTRUCTIONS
Unpack Range
Gas Supply Pressure Testing
Gas supply pressure for testing regulator must be at least
1" (2.5 cm) water column pressure above the manifold pressure
shown on the model/serial/rating plate.
Line pressure testing above 1/2 psi (3.5 Kpa) gauge
(14" [35.5 cm] WCP)
The range and its individual shutoff valve must be disconnected
from the gas supply piping system during any pressure testing of
that system at test pressures in excess of 1/2 psi (3.5 kPa).
Line pressure testing at 1/2 psi (3.5 Kpa) gauge
(14" [35.5 cm] WCP ) or lower
The range must be isolated from the gas supply piping system
by closing its individual manual shutoff valve during any pressure
testing of the gas supply piping system at test pressures equal
to or less than 1/2 psi (3.5 kPa).
4. On Ranges Equipped with a Storage Drawer:
Remove the storage drawer. See the "Storage Drawer"
section. Use a 1/4" (6.4 mm) drive ratchet to lower the rear
leveling legs one-half turn. Use a wrench or pliers to lower
front leveling legs one-half turn.
A
B
A. 1/4" (6.4 mm) drive
ratchet
B. Rear leveling leg
On Ranges Equipped with a Warming Drawer or Premium
Storage Drawer:
On ranges equipped with a warming drawer or premium storage
drawer, the rear legs cannot be accessed by removing the
warming drawer or premium storage drawer. It will be necessary
to adjust the rear legs from outside the range. Use wrench or
pliers to lower the front and rear leveling legs onehalf turn.
C
A
A. Rear leveling leg
B. Wrench or pliers
C. Front leveling leg
D
C
C.Wrench or pliers
D. Front leveling leg
B
7
Publicité
Table des Matières
