Commissioning And Startup Wizard; Commissioning Steps; Startup Wizard - Honeywell SmartDrive Compact Guide Rapide

Honeywell

4.2 COMMISSIONING AND STARTUP WIZARD

4.2.1 Commissioning steps

1. Read safety instructions on page 2
2. Secure the grounding and check that
cables comply with requirements
3. Check quality and quantity of cooling air
4. Check that all start/stop switches are in
STOP position
5. Connect the drive to mains
Table 1: Commissioning steps

4.2.2 Startup wizard

SmartDrive Compact runs the startup wizard in first power-up. After that the wizard
can be run by pressing STOP for 5 seconds in main menu. The following figures
show the procedure.
READY RUN
REF
MON
PA R
FLT
1
4-EN
NOTE! Running the startup wizard will always
return all parameter settings to their factory
STOP A LARM FAULT
Press STOP
for 5 seconds
in main menu
PERFORM THE SAME
4
PROCEDURE FOR PAR. 1.4,
MOTOR NOMINAL CURRENT
Figure 2: SmartDrive Compact startup wizard
Navigation & Startup
6. Run the Startup wizard and set all necessary
parameters
7. Perform test run without motor, see the User
Manual:
http://inverter.ecc.emea.honeywell.com
8. Run no-load tests without motor being con-
nected to the process
9. Connect the motor to the process and per-
form test run once again
10. SmartDrive Compact is now ready for use
defaults!
Alternates
in the display
READY RUN STOP ALARM
REF
MON
PAR
rp m
FLT
2
Push to enter edit mode
PERFORM DRIVE SETUP,
5
PAR. 13.2, SEE NEXT PAGE
FAULT READY R UN STOP
REF
MON
PAR
FLT
3
Select motor
nominal speed
and push
to confirm.
10
ALARM FAULT