Charging The Battery, Leds; Mounting The Charger On A Wall - Stihl Rma 443.3 Notice D'emploi

English
► Make sure that the following components are
in safe condition:
– Lawn mower,
– Blade, 4.6.2.
– Battery, 4.6.3.
– Charger, 4.6.4.
► Check the battery,
► Fully charge the battery,
► Clean the lawn mower,
► Check the blade,
► Fold up the handlebar,
► Adjust the handlebar,
► If mowing and the grass is to be collected in
the grass catcher box:
► Detach the extension,
► Open the mulch flap,
► Attach the grass catcher box,
► If mowing and the grass is to be directed to
the ground from the side:
► Close the mulch flap,
► Attach the extension,
► If mulching:
► Close the mulch flap,
► Detach the extension,
► Set the cutting height,
► Check the controls,
► If the steps cannot be performed: do not use
the lawn mower and consult a STIHL special‐
ist dealer.
6

Charging the Battery, LEDs

6.1

Mounting the charger on a wall

The charger can be mounted on a wall.
1 2
a
b
a
► Check the following points when mounting the
charger on a wall:
– Use suitable mounting materials.
– The charger is level.
The following dimensions are observed:
– a = at least 100 mm
– b (for AL 101) = 75 mm
– b (for AL 301, AL 501) = 100 mm
– c = 4.5 mm
– d = 9 mm
– e = 2.5 mm
40
4.6.1.
11.3.
6.2.
16.2.
11.2.
8.1.
8.3.
7.2.2.
12.5.1.
7.1.2.
12.5.2.
7.2.1.
12.5.2.
7.2.2.
12.2.
11.1.
3
d
e
e
6 Charging the Battery, LEDs
6.2 Charging the battery
The charging time depends on various factors,
e.g. the battery temperature or the ambient tem‐
perature. For optimum performance, observe the
recommended temperature ranges,
actual charging time may vary from the charging
time indicated. The charging time is indicated at
www.stihl.com/charging-times.
The charging process starts automatically when
the mains plug is plugged into a socket and the
battery is inserted into the charger. The charger
switches off automatically when the battery is
fully charged.
The battery and the charger warm up during
charging.
2 3
4
1
► Plug the mains plug (6) into an easily accessi‐
ble socket (7).
The charger (3) will run a self-test. The
LED (4) will glow green for about 1 second
and red for about 1 second.
► Routing the connecting cord (5).
► Insert the battery (2) in the guides in the
charger (3) and press it home as far as stop.
The LED (4) glows green. The LEDs (1) glow
green and the battery (2) is being charged.
► When the LED (4) and the LEDs (1) on the
battery no longer light up: The battery (2) is
fully charged and can be removed from the
charger (3).
► If the charger (3) is no longer required: Dis‐
connect the mains plug (6) from the wall out‐
let (7).
6.3 Displaying the state of charge
1
20.7. The
6 7
5
80-100%
60-80%
40-60%
20-40%
0-20%
0478-131-9669-B