Installation
Instructions
"If you have questions, call 800.GE.CARES or visit our website at: ge.com"
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
IMPORTANT
•
for local inspector's use.
IMPORTANT
•
codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions for
future reference.
• Product failure due to improper installation is not
covered under the Warranty.
WARNING
— This appliance must be
properly grounded.
ATTENTION INSTALLER
•
COOKTOPS MUST BE HARD WIRED (DIRECT
WIRED) INTO AN APPROVED JUNCTION BOX. A
"PLUG AND RECEPTACLE" IS NOT PERMITTED
ON THESE PRODUCTS.
• Proper installation is the responsibility of the
installer and product failure due to improper
installation is NOT covered under warranty.
PARTS INCLUDED
Foam Tape
30" Electric Cooktop
JP256
— Save these instructions
— Observe all governing
— ALL
2 Hold-Down Brackets
6 Hex-Head Screws
(4 required, 2 extra)
2 Thumbscrews
MATERIALS YOU WILL NEED
Junction Box
TOOLS YOU WILL NEED
Pencil
Phillips-Head
Screwdriver
1/4" Nut Driver
Ruler or Straightedge
Safety Glasses
12
Wire Nuts
Saber Saw
1/8" Drill Bit & Electric
or Hand Drill