Environmental Protection; Operating Modes; Exhaust Air Mode; Circulating-Air Mode - Gaggenau AW 2 Série Notice D'utilisation Et De Montage

Environmental protection

Unpack the appliance and dispose of the packaging in
an environmentally-responsible manner.
Environmental protection
This appliance is labelled in accordance with
the European Directive 2012/19/EU
concerning used electrical and electronic
appliances (WEEE – waste electrical and
electronic equipment). The guideline
determines the framework for the return and
recycling of used appliances as applicable.

Operating modes

This appliance can be used in exhaust-air mode or

circulating-air mode.

Exhaust air mode

The air which is drawn in is cleaned by
the grease filters and conveyed to the
exterior by a pipe system.
Note: The exhaust air must not be conveyed into a
functioning smoke or exhaust gas flue or into a shaft
which is used to ventilate installation rooms which
contain heat-producing appliances.
▯
Before conveying the exhaust air into a non-
functioning smoke or exhaust gas flue, obtain the
consent of the heating engineer responsible.
▯
If the exhaust air is conveyed through the outer
wall, a telescopic wall box should be used.
Circulating-air mode
The air which is drawn in is cleaned by
the grease filters and an activated
carbon filter and conveyed back into the
kitchen.
Note: To bind odours in circulating-air mode, you must
install an activated carbon filter. The different options
for operating the appliance in circulating-air mode can
be found in the brochure. Alternatively, ask your
dealer. The required accessories are available from
specialist outlets, from customer service or from the
Online Shop. The accessory numbers can be found at
the end of the instructions for use.

Operation

Note: Switch on the extractor hood when you start
cooking and switch it off again several minutes after
you have finished cooking. This is the most effective
way of removing the kitchen fumes.

Operating the appliance

Control panel
Explanation
#
Fan on/off
1 Fan speed 1
2 Fan speed 2
3 Fan speed 3
Ž

Intensive setting

<
Automatic mode
œ
Saturation indicator
c
Light on/off/dimming

Setting the fan

Switching on
ÿ
▯
Press the button.
The fan starts at setting 2.
▯
Press the 1, 2, 3 or
power level of the fan.
Switching off
#
Press the button.
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
ÿ
1 Press the button.
The fan starts at setting 2.
Ž
2 Press the button.
The intensive setting is activated.
Note: The intensive setting is a time-limited
maximum setting which can be activated at any fan
setting and in automatic mode. After approx. 6
minutes, the fan resets to the previously selected
fan setting.
3 To end the intensive setting early, press the
button or the button for another fan setting.
Ž
button to change the
ÿ
19