Preparing The Generator; Wheel Installation - Pro-Point 8953176 Mode D'emploi

8953176
I. Circuit Breaker,
8A, 12V DC
J. 120/240V, 30A
Locking
Receptacle
(NEMA L14-30R)
K. 120V, 30A Locking
Receptacle
(NEMA L5-30R)
ASSEMBLY & INSTALLATION

PREPARING THE GENERATOR

The generator requires little preparation for use once out of the box.
However, before attempting to start the generator, be sure it is ready.
1. Inspect the generator and remove any packaging inside the frame.
2. Make sure spark plug, muffler, fuel cap and air filter are in place
and secured.
3. Make sure the spark plug lead is securely connected to the spark
plug, otherwise unintentional sparking can result, causing a fire or
an electric shock.

WHEEL INSTALLATION

1. Push the axle bolt through the wheel and washer (if a washer is
supplied).
2. Push the axle bolt through the hole on the frame.
3. Push the R-pin through the hole in the axle bolt to secure it.
4. Repeat with other wheel.
Assistance available at www.princessauto.com or 1-800-665-8685
4,5000W GASOLINE INVERTER GENERATOR
L. 120V, 20A Duplex
Receptacle
(NEMA 5-20R)
M. Engine Switch
N. Status LED
O. 12 DC, 8A
Receptacle
P. Eco Switch
Q. USB Receptacle
R. Ground Bolt
S. Circuit Breaker, 30
A (2)
T. Parallel
Connection (2)
U. Circuit Breaker, 20
A
V. Power Switch
V1.0
Page 8