Publicité
Les langues disponibles
Les langues disponibles
12 ON/OFF EXTERNAL CONTROL
Use pin ON/OFF to GND (relay contact, manual switch, sensor, ..) allow control isolation of
output .
Open contact => ON output, Closed contact => OFF output.
13 MAINTENANCE
No particular maintenance is required for this instrument.
Avoid : dust, humidity, shocks ; your instrument will appreciate it.
For the cleaning, please use a smooth duster.
13.1
TROUBLESHOOTING
If indicators do not light up on switching on, check :
- The connection to mains
- The replacement of the cord can be realized only with the model :
2
3G 0.75mm
; H05VV-F; CEE7/7 - IEC60320 C13
- The mains voltage
- That the ON/OFF switch is pressed
13.2 ERROR MESSAGE
If following messages appear on the display, please contact the after sales service.
Message
"FAULT : FAILURE START-UP VOLTAGE"
"TEMPERATURE SENSOR ERROR"
"UNREGULATED CURRENT/VOLTAGE
PROTECTION"
"FAN OUT OFF ORDER"
14 AFTER SALES SERVICE
The after sales service is ensured by the elc company.
During two years, spare parts and workmanship are guaranteed. This guarantee does not
apply to instruments presenting defects or faults caused by an improper use (wrong mains
voltage, shocks ...) or which have been repaired outside our factory or the repair shops of our
authorized agencies.
4000 4 356_11-20
Connection input
control
ANALOG REMOTE
CURRENT VOLTAGE
ON/OFF
Command
Internal auxiliary power doesn't work
Internal temperature sensor doesn't work
Internal stage power doesn't work
Fan doesn't work
26
Possible cause
ENGLISH
Publicité
