Cleaning And Maintenance - Evolution R10Ts Instructions Originales

protective mask.
• Do not use any abrasive wheels.
• Use only saw blades that comply with the
characteristics specified in this manual.
• Use only saw blade diameter(s) in accordance with
the markings.
• Use only saw blades with a speed marking that
is higher than or equal to the speed marked on
the tool.
• Avoid heating the blade tips. Avoid overheating
or melting the materials. When cutting plastic, let
the tool do the work. Do not force the tool or cut too
slowly which could result in melting the plastic.
• Use only saw blades recommended by the
manufacturer, which conform to EN 847-1, if
intended for wood and analogous materials.
RESIDUAL RISKS
Even with application of safety standards and using
the tool as prescribed, certain residual risks can
remain:
• Risk of personal injury due to prolonged use.
• Risk of injury caused by dust.
• Risk of injury caused by flying objects.
• Risk of burns due to accessories becoming hot.
• Risk of electric shock due to cutting through
electric cables. When cutting through floors, ceilings
of walls ensure there are no hidden cables or water
pipes.

CLEANING AND MAINTENANCE

WARNING: Disconnect the tool from the
power source before any adjustments, cleaning, or
maintenance is carried out.
• Use compressed air to blow dirt out of the main
housing air vents and the blade guard. Wear
approved eye protection and a dust mask.
• Use a cloth dampened with water to clean the
other areas of the tool. Never use solvent based
or harsh chemicals of any type as this may weaken,
damage or destroy plastic components.
• Do not attempt to modify the tool or accessories
in any way.
• When servicing only use Evolution original parts
and carried out by a qualified person.
NOISE WARNING
WARNING: The noise emissions during actual
use of the power tool can differ from the declared
values depending on the ways in which the tool is
used especially what kind of workpiece is processed.
WARNING: The need to identify safety measures
to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger
time).
The declared noise emission value(s) have been
measured in accordance with a standard test method
and may be used for comparing one tool with another.
The declared noise emission value(s) may also be used
in a preliminary assessment of exposure.
PRODUCT OVERVIEW KEY
MACHINE OVERVIEW
A. Sliding mitre fence
B. Hold down clamp
C. Blade guard
D. Anti-kickback device
E. Riving knife
F. Rack and pinion fence
G. Outfeed support
H. Rear dust extraction port
I. Table extension locking lever
J. Stand*
K. Stand latch*
L. Sliding table top
M. Extending rails
N. Micro-adjusting dial
O. Bevel locking lever
P. ON/OFF switch
Q. Bevel / height adjusting dial
R. Push stick
S. Wrench x 2
T. Dual hex key
U. Blade
V. Outer blade flange
W. Outer blade lock nut
X. Elbow joint dust port adaptor
STAND OVERVIEW
A1 - G. Stand Components
H1 - H2. Foot Pad Components
I. Wheels (x2)
J - P. Stand Fixings
ASSEMBLY
WARNING: To reduce risk of injury, disconnect
the tool from the power source before installing,
repositioning or removing accessories. Only connect
the plug to the power source just before starting
the saw.
Assembling the stand* (figs. 1)
•
Assembling the outfeed support* (fig. 2)
•
• Assembling the bevel handle (fig. 3)
• Assembling the blade, riving knife and anti-
kickback device (fig. 4)
SETTING UP THE SAW
Using the rack and pinion fence (fig. 5)
•
EN