Publicité
Les langues disponibles
Les langues disponibles
emptying the dust cup, make sure the
vacuum is disconnected from the power,
and do not press its power button.
1. Press the dust cup bottom cover release
button, then empty the contents.
Fig. F-1
2. Push the dust cup release switch in the
direction indicated by the arrow, then gently
remove the dust cup from the vacuum.
Fig. F-2
3. Remove the pre-filter first, then lift the
handle of the cyclone assembly and turn it
counterclockwise until it stops, then pull to
lift out the cyclone assembly.
Fig. F-3
4. Wipe the dust cup with a soft wet cloth.
Pay attention to wringing out the cloth
before using.
Fig. F-4
To avoid the risk of electric shock, do not
rinse the dust cup with water.
5. Rinse the cyclone assembly and pre-
filter until they are clean. After washing,
air dry for at least 24 hours .
Fig. F-5
Note:
• It is recommended to clean the dust cup
once every month.
• It is recommended to clean the pre-filter at
least once every 3 months and the cyclone
system at least once every 6 months.
Installing the Dust Cup, Pre-
Filter, and Cyclone Assembly
1. Insert the cyclone assembly vertically into
the dust cup, and make sure that the handle
of the cyclone assembly line up with the
slot on the left side of the dust cup. Turn the
handle clockwise until it locks, then flip the
handle down.
2. Place the pre-filter with its front side
facing up into the cyclone assembly.
Fig. F-6
3. Slightly tilt the dust cup so the slot aligns
with the clip on the vacuum. Then gently
push the dust cup until it clicks into place.
Fig. F-7
Cleaning the Filter
It is recommended to clean the filter once
every 4 to 6 months.
1. Remove the dust cup as shown in the
figure.
Fig. F-8
2. Remove the filter from the vacuum by
pulling it down in the direction shown in
the figure.
Fig. F-9
3. Clean the filter with clean water.
Make sure you rotate the filter 360° to
thoroughly and remove all dust caught
in the filter. Lightly tap the filter several
times to remove any excess dirt.
Fig. F-10
4. Allow the filter to air dry for 24 hours.
Fig. F-11
Note：
• Only use clean water to wash the filter. Do
not use detergent.
• Do not attempt to clean the filter with a
brush or finger.
Installing the filter
1. Insert the filter into the vacuum and
gently press down, as illustrated.
Fig. F-12
2. Reinstall the dust cup.
Fig. F-13
Cleaning the Multi-Surface
Brush
1. Turn the lock counterclockwise until it
stops, then remove the roller from the roller
brush.
Fig. F-14
2. Use scissors to cut off the hairs and fibers
that get stuck on the brush roller. Wipe the
dust from the notch and transparent cover
EN
5
Publicité
