Technical Data; Before Putting The Machine Into Operation - HERKULES KSZ 4300 Mode D'emploi D'origine

Anleitung_KSZ_4300_SPK7:_
The same applies for the general rules of
occupational health and safety.
The manufacturer shall not be liable for any changes
made to the machine nor for any damage resulting
from such changes.
Even when the machine is used as prescribed it is
still impossible to eliminate certain residual risk
factors. The following hazards may arise in
connection with the machineʼs construction and
design:
Contact with the saw blade in the uncovered saw
zone.
Reaching into the running saw blade (cut
injuries).
Kick-back of workpieces and parts of workpieces.
Saw blade fracturing.
Catapulting of faulty carbide tips from the saw
blade.
Damage to hearing if essential ear-muffs are not
worn.
Harmful emissions of wood dust when the
machine is used in closed rooms.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

5. Technical data

Asynchronous motor
Output
Operating mode
Idle speed n
0
Carbide-tipped saw blade
Number of teeth
Tilting range
Mitre cuts
Sawing width at 90°
Sawing width at 45°
Sawing width at 2 x 45°
(double mitre cuts)
Weight
Laser class
Laser wave length
Laser output
Laser module power supply
02.10.2009 8:50 Uhr
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029.
L sound pressure level
pA
K uncertainty
pA
L
WA
K
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Vibration emission value a
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
230 V ~ 50 Hz
Switch the appliance off when it is not in use.
Wear protective gloves.
2000 W
S1
6. Before putting the machine into
4800 min -1
operation
ø 250 x ø 30 x 3,0 mm
60
The machine must be firmly mounted in working
-45° / 0°/ +60° position, e.g. on a workbench, the base frame
supplied with the machine, or similar.
0° to 45° to the left
All the covers and safety devices have to be
430 x 75 mm
properly fitted before the machine is switched on.
It must be possible for the saw blade to run
300 x 75 mm
freely.
When working with wood that has been
300 x 40 mm
processed before, watch out for foreign bodies
such as nails or screws etc.
18 kg
Before you actuate the On/Off switch, make sure
2
that the saw blade is correctly fitted and that the
machineʼs moving parts run smoothly.
650 nm
Before you connect the machine to the power
≤ 1 mW
supply, make sure the data on the rating plate is
2 x 1.5 V Micro (AAA
the same as that for your mains.
Seite 11
sound power level
uncertainty
≤ 2.5 m/s
h
GB
Idle speed
91.4 dB(A)
3 dB
104.4 dB(A)
3 dB
2
11