Technical Data - HERKULES BKS 315/230 Mode D'emploi

Anleitung BKS 315-230 SPK 7 V5
Important:
Risk of injury!
Never reach into the running
saw blade.
Wear goggles
Wear ear-muffs
Wear a breathing mask
Noise emission values
Idle mode
Sound pressure level LPA 92,9 dB(A)
Sound power level LWA 103,5 dB(A) 93,7 dB(A)
The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immission
level at the workplace include the duration of impact,
the type of room, and other sources of noise etc.,
e.g. the number of machines and other neighboring
operations. Reliable workplace values may also vary
from country to country. With this information the
user should at least be able to make a better
assessment of the dangers and risks involved.

5. Technical data

AC motor 230 V
Power P
Power P S6 20% 2000 W
Idle speed n
0
Cutting-off wheel Ø 315 x Ø 30 x 3,6 mm
Number of teeth
Table size 800 x 550 mm
Cutting height max.
60 mm / 45°
Height adjustment infinite 0 -83 mm
04.07.2005 7:24 Uhr
Tilting saw blade
Extractor socket
6. Before putting the machine into
operation
Unpack the bench-type circular saw and check it
for damage which may have occurred in transit.
The machine has to be set up where it can stand
firmly, e.g. on a work bench, or it must be bolted
to a strong base. The machine must stand
securely, i.e. the saw must be securely bolted to
the floor.
All covers and safety devices have to be
properly fitted before the machine is switched
on.
It must be possible for the saw blade to run
freely.
When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws etc.
82,9 dB(A)
Before you actuate the On/Off switch, make sure
that the saw blade is correctly fitted and that the
machine's moving parts run smoothly.
Before you connect the machine to the power
supply, make sure the data on the rating plate is
the same as that for your mains.
7. Assembly
Important! Pull out the power plug before
carrying out any maintenance, resetting or
assembly work on the cutting-off machine!
7.1. Setting up the saw (Fig. 1-6)
Place the saw table on a flat surface.
Screw the feet (18) and the saw table (1) loosely
together.
Important: It is imperative that the foot with the
opening (19) for the switch/plug block is
50Hz
mounted correctly on the left front side (see Fig.
S1 1200 W
1; 2; 6).
Screw the side struts (24) and the legs (18,19)
loosely together.
2800 min -1
Fasten the extractor connection to the bottom of
the chip box (17) with 4 screws (32) (Fig. 3).
24
Mount the four rubber feet (25) on the legs.
Working from the inside, fit the mounting for the
chassis (22) to the rear legs (18) with 4 screws
83 mm / 0°
(33). (Fig. 4)
Turn the saw upside down and place it on the
legs.
Seite 19
GB
infinite 0° - 45°
Ø 100 mm
19