Technical Data; Before Putting The Machine Into Operation - HERKULES ZGS 3300 UG Mode D'emploi D'origine

Anleitung_ZGS_3300_UG_SPK7:_

5. Technical data

Asynchronous motor
Output
Operating mode
Idle speed n
0
Carbide-tipped saw blade
Number of teeth
Tilting range
Mitre cuts
Saw bed support
Sawing width at 90°
Sawing width at 45°
Sawing width at 2 x 45°
(double mitre cuts)
Safety insulated
Weight
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Vibration emission value a = 2.63 m/s
h
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
27.04.2011 11:22 Uhr
The specified vibration value can be used for initial
assessment of a harmful effect.
230 V ~ 50 Hz
Keep the noise emissions and vibrations to a
1600 W
minimum.
S1 Only use appliances which are in perfect working
order.
4200 min -1
Service and clean the appliance regularly.
ø 305 x ø 30 x 3.2 mm
Adapt your working style to suit the appliance.
60
Do not overload the appliance.
-45° / 0° / +45° Have the appliance serviced whenever
necessary.
0° to 45° to the left
Switch the appliance off when it is not in use.
515 x 360 mm
Wear protective gloves.
330 x 102 mm
230 x 102 mm
6. Before putting the machine into
operation
230 x 65 mm
II / ®
The machine must be set up where it can stand
36,2 kg
securely, i.e. it should be bolted to a workbench,
a universal base frame or similar.
All covers and safety devices have to be properly
fitted before the machine is switched on.
It must be possible for the saw blade to run
freely.
When working with wood that has been
processed before, watch out for foreign bodies
Idle speed
such as nails or screws etc.
95.9 dB(A)
Before you actuate the On/Off switch, make sure
3 dB
that the saw blade is correctly fitted and that the
108.9 dB(A)
machine's moving parts run smoothly.
Before you connect the machine to the power
3 dB
supply, make sure the data on the rating plate is
the same as that for your mains.
Important:
2 This machine was exactly adjusted before it left the
factory. For the best results you should check the
accuracy of the following settings and make
corrections as necessary.
6.1 Setting the angle stop to 90° and 45° (Fig.
5/6/7)
Release the angle clamping lever (13) and move
the cutting head (4) all the way to the right.
Secure the angle clamping lever (13).
Use an angular stop (a/b) to set the blade at 90°
in relation to the table.
If an adjustment is necessary, undo the locknut
(d) and turn the screw (c) so that the blade
makes an angle of 90° with the table.
Tighten the locknut (d).
Use the screw (c) to set the angle indicator (15)
to 0.
Seite 11
GB
11