Overview Of The Basic Settings; Cleaning And Servicing; Cleaning Products - Junker JR36DT5 Manuel D'utilisation

8 Basic settings
You can configure the appliance to meet your needs.
8.1 Overview of the basic settings
You can find an overview of the basic settings and the
default factory settings here.
Dis- Selection
play
Automatic childproof lock
– Switched off
– Switched on
– Manual and automatic childproof lock are
switched off.
Signal tone
– Confirmation signal and operating error
signal are switched off. The main switch sig-
nal remains switched on.
– Only the operating error signal is
switched on.
– Only the confirmation signal is switched
on.
– Confirmation signal and operating error
signal are switched on.
Time for selecting hotplates
– Unlimited: The last hotplate selected can
always be adjusted without having to select it
1
again.
– You can adjust the last hotplate selected
within 10 seconds after selecting it. After this
time you have to select the hotplate again be-
fore adjusting it.
Resetting to the factory settings
– Switched off.
– Switched on.
1 Factory setting
8.2 Changing basic settings
Requirement: The hob is switched off.
9 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
9.1 Cleaning products
You can obtain suitable cleaning products and glass
scrapers from customer service, the online shop or a
retailer.
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
Never use unsuitable cleaning products.
▶
Unsuitable cleaning products
¡ Undiluted detergent
¡ Detergent intended for dishwashers
¡ Abrasive cleaners
1
1
1
Switch on the hob.
1.
Within the next 10 seconds press and hold
2.
approx. 4 seconds.
a and flash alternately on the lower display.
lights up on the upper display.
a
Repeatedly touch
3.
pears on the lower display.
4. Set the required value on the control panel.
Press and hold
5.
a The setting is activated.
Tip: To exit the basic settings without saving, switch off
the hob using . Switch the hob on again and reset.
¡ Aggressive cleaning products such as oven spray
or stain remover
¡ Abrasive sponges
¡ High-pressure or steam jet cleaners
9.2 Cleaning the glass ceramic
Clean the hob after every use to stop cooking residues
from getting burnt on.
Note: Note the information on unsuitable cleaning
products. → Page 29
Requirement: The hob has cooled down.
Remove heavy soiling using a glass scraper.
1.
Clean the hob with a cleaning product for glass
2.
ceramic.
Follow the cleaning instructions on the product
packaging.
Basic settings en
until the required indicator ap-
for 4 seconds.
for
29