Changing The Basic Settings; Cleaning; Ceramic; Hob Surround - Junker JR36ET54 Notice D'utilisation

Display Function
Activation of the heating elements
™ˆ
Switched off.
‹
Switched on.
‚
Last setting before the hotplate was switched off.*
ƒ
Selected time for the hotplate
™Š
Unlimited: the most recently selected hotplate can always
‹
be adjusted without having to select it again.*
Once you select a hotplate, you have 10 seconds to adjust
‚
it, after which you will have to select it again in order to be
able to adjust it.
™‹ Reset the basic settings
Switched off.*
‹
Switched on.
‚
*Basic setting

Changing the basic settings

The hob must be switched off.
Switch on the hob.
1.
Within the next 10 seconds, touch and hold the
2.
symbol for 4 seconds.
and flash alternately in the left-hand display;
™ ‚
up in the right-hand display.
Touch the symbol repeatedly until the required
Î
3.
display appears in the left-hand display.
Touch the + or - symbol repeatedly until the desired
4.
setting appears in the display.
Touch the symbol for 4 seconds.
Î
5.
The setting is activated.
Switching off
To exit the basic setting, switch off the hob with the
main switch and make new settings.
Î
DCleaning
Suitable maintenance and cleaning products can be
C l e a n i n g
purchased from the after-sales service or in our e-Shop.

Ceramic

Clean the hob after each use. This will prevent spills
from burning onto the ceramic.
Only clean the hob when it has cooled down sufficiently.
Use only cleaning agents which are suitable for glass
ceramic. Follow the cleaning instructions on the
packaging.
Never use:
Undiluted washing-up liquid
■
Detergent intended for dishwashers
■
Scouring agents
■
Harsh cleaning agents such as oven spray or stain
■
remover
Abrasive sponges
■
High-pressure cleaners or steam jet cleaners
■
Ground-in dirt can be best removed with a glass
scraper, available from retailers. Please note the
manufacturer's instructions.
Î
You can also obtain a suitable glass scraper from our
after-sales service or from the e-Shop.
Using special sponges to clean glass ceramic achieves
great cleaning results.

Hob surround

To prevent damage to the hob surround, observe the
following instructions:
Use only hot soapy water.
■
Wash new sponge cloths thoroughly before use.
■
Do not use any sharp or abrasive agents.
■
lights
‹
Do not use the glass scraper.
■

Cleaning

en
31