Publicité
Les langues disponibles
Les langues disponibles
en-us Removing the appliance
When changing the configuration, an electrician must re-
initialize the system.
8.1 Networking appliances
Requirement: A qualified electrician networks the
appliances.
Connect the appliances in series via the connector
1.
sockets X1 and X2.
X1 and X2 are equivalent.
The sequence of the networking does not have any
effect.
If the enclosed network cables are too short, use a
2.
commercially available network cable (shielded, min.
CAT 5).
8.2 Re-initializing the system
Requirement: A qualified electrician carries out the
initialization and the test.
Unscrew the cover plate.
1.
Press and hold the reset button until both LEDs light up
2.
continuously.
Press and hold the reset button for
‒
approx. 5 seconds.
Release the reset button within 5 seconds.
‒
Screw on the cover plate.
3.
16
Check that the system is working correctly.
4.
9 Removing the appliance
Removing the appliance
Removing the appliance
WARNING
The appliance is heavy.
To move the appliance, two people are required.
▶
Use only suitable tools and equipment.
▶
Components inside the appliance may have sharp edges.
Wear protective gloves.
▶
NOTICE:
Tools may damage the appliance.
Do not prize out the appliance from above.
▶
Disconnect the appliance from the power supply.
1.
If the appliance is flush-mounted with the surrounding
2.
surfaces, remove the silicone seal.
Push out the appliance from below.
3.
10 Customer Service
Customer Service
With any warranty repair, we will make sure your
Customer Service
appliance is repaired by an authorized service provider
using genuine replacement parts. We use only genuine
replacement parts for all repairs.
Detailed information on the warranty period and terms of
warranty can be found in the Statement of Limited Product
Warranty, from your retailer, or on our website.
If you contact Customer Service, you will need the model
number (E-Nr.) and the production number (FD) of your
appliance.
The LED light sources are available as a spare part and
should only be replaced by an authorized service provider.
USA:
1-877-442-4436
www.gaggenau.com
www.gaggenau.com/us/appliances/eshop
CA:
1-877-442-4436
www.gaggenau.com
www.gaggenau.ca
10.1 Model number (E-Nr.) and production
number (FD)
You can find the model number (E-Nr.) and the production
number (FD) on the appliance's rating plate.
The rating plate is located at the bottom on the front of the
appliance. To find it, open the door of the base cabinet in
which the appliance is installed.
Making a note of your appliance's details and the
Customer Service telephone number will enable you to
find them again quickly.
Publicité
