Publicité
Les langues disponibles
Les langues disponibles
Ensure that the angle of the cut surface to the
3.
countertop is 90°.
Seal the cut surfaces so that they are heat-resistant and
4.
waterproof.
Ensure that the countertop has sufficient load-bearing
5.
capacity and stability. Use a heat- and humidity-
resistant reinforcing material for any substructure.
Ensure that the cabinet is still stable after the cutouts
6.
have been made.
Observe the minimum clearances of ⅜" (10 mm)
7.
between the bottom of the appliance and furniture parts.
Remove any shavings.
8.
6.3 Removing the transit bolts
Unscrew the 2 panels on the front of the appliance.
1.
Unscrew the 2 screws on the underside of the
2.
appliance.
Close off the holes on the underside of the appliance
3.
using the locking caps.
Installation en-us
11
Publicité
